Search results

Hi i have just fitted a bathroom suite and now im left with a gap between the bath edge and the wall.Originaly i filled this gap with some wood and tried to seal it with silicone, tiles and grout; but being at the shower end, due to the pipe work being in the way it seems to be leaking. Have any...

sounds like the engines flooded to me try putting full throttle on and hold it there when you crank the engine and keep it cranking for about 20-30 secs max.

the problem sounds like the coil pack which cost about £120 but if your in the aa call them out as they carry these coils and you will save on labour charges and will be able to reset the engine light,hope this helps,jim

yes its enabled and working properly as i can load drivers etc from the drive with no problems

ive tried holding c key didnt work,i've also tried START-RUN- then enterd cd-rom d:\setup.exe but it comes up as cd rom drive not found,made sure that the drive is enabled in device manager.

hi i have found the boot options but there is no option for the cd rom.is there a way of enableing the cd rom.if so could you tell me pls.and thanks for the repls many thanks.jim

sorry, i had it with no operating system on it.i loaded xp onto it and it worked fine for a while then it went tits up and takes ages for it to boot up so i want to start again by formatting hhd and reinstalling xp from the cd roms i have,also how do i configuer my laptop to boot from cd rom?

hi i have a compaq evo n600c laptop with xp media on it but since i loaded xp its started not to boot up.is there any way of formatting the hhd and reinstalling xp from the oreiginal cd i have?many thanks for any replies.p.s im a right noob

I'll think you'll find that the piston might wind back in anti clockwise as i found this to be the case on a mondeos rear caliper,hope this helps.

Im pretty sure that it is under the bonnet on the passenger side at the back.

Hi if the fan stops when you unplug it from the rad that is going to be the fan switch for sure,best thing to do is take it out of the rad and take it with you when you purchase another one,jim.

Hi if its a pretty late model sayy 99 on its going to be ignition coil as its one unit for all four cylinders,one breaks down and thats it run like a bag of sh*t

Hi its not a main dealer job but you do need a good garage with good diagnostic equipment and they will sort you out,what part of the country you from?

Hi for some reason when i turner my pc on last time and tried to load a dvd it appears that the computer is notdetecting the dvd drive,any ideas pls.

Hi i agree with cjbigboy i would change the idle air control valve as i have also done loads of these.

Hi this is an easy one,first take off the cowling from around the steering column, you will now see a black ring around the ignition barrel held on by one screw,remove screw and remove the black plastic ring, now remove the ignition switch off the back of the barrel, put key back into the barrel...

Hi im working on a mk4 fiesta 1.25 for my mate and will have a nose about tomorrow for ya if thats helps you out, i'll get back to you tomorrow, jim.

Hi it sounds like the resister has gone,knowing ford it is more likley to be near the fan blower but not sure,you need to have a look about,hope this helps,jim.

Hi mate, yes there is a table of tyre pressures its just knowing were to get one, i suggest a web search.

Try opening the bonnet and see on the bulkhead theres a rubber drain pipe, these tend to block causing water to leak into the vehicle,mainly block with leaves etc.jim.