Search results

Middle clamp in photograph is set up correctly.uppermost part of clamp (red/part) rests on underside of bath.Bottom red part and rest of clamp go against the wall. Drill wall and fix with bolt through slotted hole using blue rawl plugs and clamp bath to wall with wingnut.Hope this helps. Steve

Yes but you also have to inform building control. Steve

Cheers doitall just thought i'd double check no offence but as i said i needed a definative answer. Thanks again Steve

Thanks for your help, just checked corgi site new appliances should be safety checked within 12 months of their installation date. Steve

Cheers Doitall but i really need a definitive answer,are you an rgi?

I am a landlord,aswell as the usual corgi benchmark cert when a boiler is replaced do do i need a full gas safety check aswell? Thanks Steve

Heaven knows! " But if you're gonna do it, do it right, right?" :D

Because 2.5mm can take 27A, i know a dso is max 26A and then an allowance for diversity can be made but; Best practise if your "spurring at the mcb" is to assume that someone will convert it to a radial circuit in the future, so larger cable is better. Steve

Stefan plant I your still following this thread and you still wish to run the new circuit from the cu from a ring final (ie 32A mcb protection) i would run it in 4mm. Steve

Securespark I stand corrected if its a ring final :oops: I know its frequently seen but not best practice. Steve

reg 314-01-04 Its two individual circuits!

No! Where an installation comprises more than one final circuit,each final circuit shall be connected to a separate way in a distribution board. The wiring of each final circuit shall be electrically seperate from that of every other final circuit, so as to prevent the indirect energising of...

Mira magna, bit pricey but superb performance.Handy being able to hide digital mixer outside bathroom ie loft, airing cupboard. steve

tns :shock:

Had a similar fault once with copper pipes (heating/hot water) buried in concrete floor, pipes had fractured and allowed the c/w cistern to fill the f/e tank!

I would hope he's not missed something as simple as that looking at the gas cert he's done recently operating pressure of living room fire is 17mb

Please help boiler fitted approx 3 years ago. central heating ok hot water very poor,heating engineer has replaced several parts-plate heat exchanger,thermistor, complete divertor assembly and finally a new gas valve. He's now thrown the towel in saying he can't adjust gas valve past 5mb...