Search results

Didn’t happen to lose the front tamper spring by accident? Done that before the pesky thing flew off without me noticing

Engineer utilities > confirm devices > network 1 What is displayed in there?

Probably when it was installed! Haha Open panel disconnect battery and isolate mains power. I’d imagine your external bell is already dead and won’t cause any issue

OP is referring to Exit Route tone so hallway activating upon exit route. Only solution to this is as mentioned silent the exit tone, get the app or a keyfob-we and arm from outside save using the keypad and hearing the tones

Alarm junction box

Area A exit mode set to final exit?

Really simple to back door the system and gain engineer access no re-programming required PM’d you

If you have no issues with the alarm I would leave it, flashing the firmware could possibly cause you more headaches. Various texecom wireless sensors, depends on the environment its going, how sensitive you want that sensor, type of detection that could prevent false alarms etc…

You’re correct in your assumption, and no it doesn’t matter which way round you wire the pairs as long as the blue and yellow are used in NC, green and white as tamper

Keypad 0 zones are 73 and 74

Mains off , disconnect standby battery. Bell will sound off for 20mins then stop.

Pyronix KX15DQ, Not pet friendly

Completely false. 100% pyronix easiest systems to install and set up

Tried default codes? 0>7890

Eufy doorbell no subscription

Any brand will work; recommend pyronix delta bell easy to connect

Change engineer code- Enter engineer code, press no until it says change codes press yes on that Then yes again Followed by no until it says change engineer code press yes Press C to clear existing Enter new code followed by yes Press no until it shows CHANGE CODES again. press A to save and exit

Change master code - press D , enter your master code press no until it asks to change codes or edit users. Press yes on that then no until it says change master code. Press the C button to clear existing and then type New code followed by the yes button. Press no until it says change codes/edit...

As Sparky said, wrong IP range possibly gateway set for old router IP on a different range. Enable dhcp then disable.