Search results

Mains Power Failure Alarm 3 https://www.amazon.co.uk/dp/B01HFBVEK6/ref=cm_sw_r_cp_api_glt_fabc_90YH8WMQZEEJVN3K9X67

By default it’s off(ext), once wired up move it to on(int). Bottom jumper I think it’s JP9 on the board

Test failed due to the pir being missing/tamper should just press yes to go back into engineers mode and either remove the device from wireless devices+inputs or put the lid back on it for time being

Do you have an engineers code? Programming for zone set up is done in the engineers menu

Yes sparky is correct Zone2 can only be an entry ROUTE or Alarm not a entry/exit

No it isn’t. There is programming involved but if you are slightly savvy and research/read manuals/watch videos it’s achievable

this is correct

I’ve PM’d you

The Pyronix enforcer kits do come with bell module but you need a dummy bell housing for it to be mounted in.

followed the whole SMS set up from the manual?

Twist them together keep them tidy, do NOT cut them flush you may need spare cores for a number of reasons in the future

Pyronix website

Pyronix Euro much simpler for domestic than texecom in my opinion

circled in yellow is your 12v quick blow

Surely dropping the mains and battery to the system then powering back up will put it back to an unarmed state?

Texecom psu curse..... replace

Doh! Well every day is a learning day haha

How was zone C armed? Do you have any remote key fobs or prox tags that’s could be used?

First quote is only for 4channel NVR?