Search results

You would be correct to replace the bell battery, Siren = Bell. Battery has got too low that it’s lost signal with the panel

You need the engineer code to learn devices onto the system

That code is default master user can I assume you have tried 1111?

What code do you have, 1111?

Yes you can migrate the account, did you install the system? You need to have access to the pyronix cloud admin account that has the authorisation for your system. Then from there you will see your phone with home control access authorised and your phone with pro control access not authorised...

Correct, not needed on wireless

Do you still have contact for the engineer? Tried the default engineer code? If all else fails you can back door the system if your alarm is non maintained to reset the engineer code only

If the back seems flush too, this screw may need tightening to bring the tamper switch off the wall towards the lid

The bell is in tamper so the lid isn’t sitting flush or it’s not tight enough to the wall.

https://www.broadbandbuyer.com/products/28800-ubiquiti-nbe-5ac-gen2-pnp/?gclid=EAIaIQobChMIuOHs0_TN7QIVTbDtCh0kuQCJEAQYASABEgL1ovD_BwE

We usually fit Ubiquiti Nano beams for these jobs

Mk2, try re-learning onto system first. If it still doesn’t sound then new bell module

I ripped out a wireless Yale system this week. Took the devices off walls and doors the bell and internal hub didn't bat an eyelid. Disconnected the hub and still the bell didn’t sound, even taking the lid off the bell it made no noise. Obviously I’m not guaranteeing yours won’t make any noise...

Yes, mk2 roughly 3years old I believe

I had one go faulty today after a battery change. Had to swap bell module

Obviously wired would be better but isn’t possible for every install.

Euro 46s with digi Wi-fi. First year with the cloud is free when you register as an end user.

This video sums ups the basics of it pretty well, notifications are set up in the linkage page. Make sure Notify Surveillance Centre is ticked.

Fantastic. notifications, double check the app - More(bottom right) - settings - enable push notifications. Then check your phone settings to make sure they’re enabled. Other than that it’s checking the DVR to make sure that the line crossing or intrusions zones are set up correctly in the...

Are you using the add device scan qr option from the pro control menu or are you just using the phones main camera?