Search results

Control panel is the larger box

Put control panel in engineering mode if possible. If not use user code to cancell noise. Open control panel lid,remove the 4 screws holding pcb cover. Speaker top left corner with molex connection. Unplug lead,remove piezo from holder and replace with new piezo. Now replace lid and screw,close...

Take keypad apart and clean pcb and rubber keypad carbon studs with methylated spirits Or Hire a Medium !!!!

I don't think they are compatible. Your best option would be to phone Yale tech support .

Make and model of new system may help?

Y9u need to choose the right camera if you have low light levels, otherwise you will see nothing in the early hours. 8 cameras would recommend 6/8 Tb hard drive.

You need to determine what you want the camera to cover/identify. Do you need supplementary lighting. Cameras that use infra red have different ranges of coverage. Poor lit areas tend to have poor images if not setup correctly. Swann are a budget product.I would steer clear of Swann. What...

Good practice to change all batteries in all your wireless devices at same time.This will stop your random battery issues.

Yes Purchase a LCDP keypad site at front door and connect to bus connections + - TR. You will need to address the keypad via dil switches on keypad. Wiring diagram are available in the installation manual which you can download.

You can use aux volt terminals that pir are connected to or bell + & bell -.

Yes There are YouTube videos on how to setup panic button on Internet.

Connect +12v & -12v to aux volts on control panel. SPK to SPK on control panel BA to Bell on control panel TT is the tamper which will be connected to a zone tamper if required, but not necessary. If any speaker inference then resistor needs to be fitted as diagram.

Just take the all the green and white out of the aux connection and put them back in when you have extended cable. Extending the bell wire will cause bell to ring,unless you disconnect at the outside bell.

Take aux volts connection out of control panel and extend cable with these junction boxes. Reconnect in panel.no programming required.

Yes ,we always use p clips to secure link cable to junction box

No Junction box usually positioned to allow for cable length of pre made contact.

Remember to allow for the expansion and contraction of the timber of the Cabin. I have seen sockets pulled of the timber when the wood shrinks during the summer.

That's an upto date version. You will need an installer ID to connect system to the cloud.

Yes,but depends on what version of software your control panel is. Press menu 4 this will tell.

Install a Smartcom then you can use the Texecom Connect on mobiles