Search results

It may not have one.

If the fibre glass bandage goes right round the pipe it can't fall off. If the pipe surface is clean and dry (that might be difficult) the resin should bond to it (check the instructions re suitable materials).

If it's running you should be able to feel/hear slight vibration of the pump. Check on each speed setting. If the speed settings produce no noticeable difference then I'd suspect a faulty pump motor winding. Setting the pump to maximum speed would likely help with clearing any air-lock.

Circulation pump not fully functional? Air in pipework? Welcome to DIYnot!

The quote will depend on such things as whether scaffolding, cherry-picker or just ladders are necessary for safe access. Post a pic or two.

Can what appears to be a tab bordering that hole be moved away from the knob?

Try pulling harder! :giggle: Actually, it looks as though the small dents in the sides of the knobs could be effectively riveting them on to the levers, so removal might require use of a small angle grinder.

You probably need a lot more turns than 'a couple'; even complete removal of the screw. Apart from the rubber washer there may be sediment blocking the outlet.

Surely you could paint the panel to blend in with the surround?

Judging by the ones in public conveniences, more pee goes on the floor than in the urinal :giggle:.

In the centre of the fan are two small red DIP-switches. Are they set corectly? (They are currently both set to OFF).

What is the source providing power to the USB cable? How much current to the gloves currently draw? How much space do you have available for an adapter to go between the source and the cable? Would you be able to build an adapter or are you dependent on hving to buy an off-the-shelf one?

Get a clamp-on raised seat from a disability aids shop? It may not have a lid, but that is a minor matter.

That would work; or simply use fatter/longer screws in the existing holes.

In the average new-build, opening a window inwards would halve the living space in the room :giggle:

Can you push a thin-bladed screw-driver down the gap between that rod and the central protrusion?

It's unfortunate that Windows error messages are so cryptic. No doubt they mean something to the developers, but it would be helpful if they were more informative for the end users, e.g. by pointing out that the reserved partition size needs increasing.to accommodate all the bloatware.

Does the central plastic protrusion, between the push rods, move down at all?

Does the central plastic protrusion, between the push rods, move down to allow the chromed bezel to rotate together with the rods?

Additional resistance in circuit, due to a poor connection anywhere in the series string, is also a possible cause for the dimness.