Search results

  1. jeff the gasman

    Potterton PTT2 noisy - clean? faulty? replace (seems impossible!)

    If the chatter comes from a load carrying relay the arcing can cause a heat build up. Not low voltage contacts.
  2. jeff the gasman

    Potterton PTT2 noisy - clean? faulty? replace (seems impossible!)

    https://www.ephcontrols.com/wp-content/uploads/2017/05/20180627_CDC_InsIns_JW.pdf
  3. jeff the gasman

    Potterton PTT2 noisy - clean? faulty? replace (seems impossible!)

    Get it replaced before it starts a fire.
  4. jeff the gasman

    Suddenly I've got no water upstairs, but no evidence of leaks anywhere

    No mate. Could be a tap cartridge fault if it’s only one tap! Does the washing machine fill?
  5. jeff the gasman

    Prima 50F - is this likely a PCB issue?

    Portmanteau! That’s a big word for a Matelot! X
  6. jeff the gasman

    Suddenly I've got no water upstairs, but no evidence of leaks anywhere

    Sounds to me like a stop tap has been fitted back to front. The loose jumper acting as a check valve. Can’t happen with a lever valve though.
  7. jeff the gasman

    Toilet cistern slow leak

    Get one of these. https://plumbinbits.co.uk/product/viva-foam-washer-pp0035/
  8. jeff the gasman

    Toilet cistern slow leak

    Looking at the pictures you’re already over your capabilities on this!
  9. jeff the gasman

    Toilet cistern slow leak

    You’ll need to remove the cistern and fit a new Donut washer between the pan and cistern. Check tightness of flush valve at the same time.
  10. jeff the gasman

    Stains On Wooden Floor Caused By Underfloor Heating?

    Check the heating system pressure and if it’s low, top it up to 1 bar. The pressure should hold steady. If it doesn’t, you have a leak.
  11. jeff the gasman

    Stains On Wooden Floor Caused By Underfloor Heating?

    You don’t have much choice. Monitor the situation.
  12. jeff the gasman

    Stains On Wooden Floor Caused By Underfloor Heating?

    Could be damp permeating from below. Floors take a long time to fully dry. And should be dry before laying flooring.
  13. jeff the gasman

    Quality wall repair

    That’s catapult Kenny’s work!
  14. jeff the gasman

    Is it ok to use copper pipes with stainless cylinder?

    Copper is fine!
  15. jeff the gasman

    Any one know what these symbols mean on my Vaillant Ecotech boiler...

    You need a gas safe engineer for that Steve. Or a fixed price Vaillant repair.
  16. jeff the gasman

    Triton push-fit bar mixer bracket dilemma

    What @Elkato531 said
  17. jeff the gasman

    Concrete water tank connector

    Fit a siphon pipe instead. Once primed it’ll run forever or until yo run out of water.
  18. jeff the gasman

    Any reason to move a new boiler?

    What boiler do you have? If you already had a full tank of hot water the pump wouldn’t respond to the demand from the programmer.
  19. jeff the gasman

    Any reason to move a new boiler?

    There’s a lot of misinformed views here! Relocation may be down to flue clearances or accessibility to hot and cold supplies. I’m sure someone would be able to give you their reasons for relocating. Pay no attention to those knocking combi boilers. Far less gas used for hot water in a normal...
  20. jeff the gasman

    Quality of plastering workmanship advice?

    Bet it was catapult Kenny!
Back
Top