Search results

We just use blobs on the floor where the circles are going to be and then whatever’s left in the mixing bucket gets blobbed all over The moulding doesn’t have to be filled, just make sure you get a good bed of rapid set all over under the tray, and it’ll be fine

We fit exactly the same, Stone resin MX shower trays If I was doing yours I would secure all floorboards/chipboard under the tray, cut 12mm ply 1800x760, the Mx trays are actually 5 to 10mm bigger than the size stated, so the ply just sits away from the edge of the tray, put a screw every 6”...

Our company fit 3-4 MX trays per week, and we always use flexible floor tile adhesive, I’ve never fitted a tray on a sand and cement and I never will

You’ve already got a trap on the tray, just remove the p-trap, and replace with pipe and fittings

Remove the P-trap and replace with 40mm fittings and pipe

If I’ve read that right, bin the p trap off, as you will already have a trap on the tray

I use jointing paste

How do the bracket sizes compare with the myson and Quinn what’s the average cost per inch of the radiators how does colouring match up to other radiators on the market lol

Jesus Christ what answer are you actually after lol

Maybe, but I fit what I’m happy with and the quality, probably still fitted more radiators in a week than you have in your life

I’ve fitted 5 tops Myson radiators and roughly 50/60 Stelrad

I prefer Quinn radiators, never had any problems and fitted hundreds of them over the years

Sounds like the heat exchanger is blocked

Have you tried turning the temperature of the hot water up on the boiler ? stop tap opened fully ?

Blockage in the pipe Fall isn’t enough or falling the wrong way if the pipes are clear and falling the right way, put a non-return on the bath waste pipe

That’s rough as ****, I dread to think what the plumbing is like that you can’t see

The fixing are behind the grey plastic rectangles, pop them out with a thin screwdriver or Stanley blade

Too cheap for me that, as for pricing all depends on pipe run lengths, condition of floors, walls, to many variables to give a price without seeing, or knowing any measurements

Do whatever you got told when you did your unvented course, I often use my Btec book if I ever get stuck

The amount of time you’ve spent on this forum, I bet I could of filled and painted that hole lol