Search results

  1. B

    Golf 2013 Mk 7 rear washer blocked

    The washer pipe may be kinked when the tail gate shuts, have you tried working rear washer when tailgate open? check washer pipe at tailgate aperture (from body of car to tailgate)
  2. B

    tectite fitting on my shower

    You need a realise tool try this link http://tectite.co.uk/EN/ProductDetails?Id=a77999b0-03c2-4654-906f-6a5639dbcf29&Rid=b030dcb1-b794-4b48-a72b-7a003167d369&d=0
  3. B

    turning a window to a door...

    Is that a boiler flue by arched bricks ? if so may be to near(planned door) for regs ?
  4. B

    Replacing air-con condensor Vectra C 1.8 petrol

    I remember when we use to take lumps out our foreman at the time would go made if we did not seal up open ends of unions on aircons pipes due to the damage to the dryers .but did try and keep awsy from aircons if i could . Cheers john.
  5. B

    Replacing air-con condensor Vectra C 1.8 petrol

    Might do john .but when i was in the trade.rover man.dryer was stand slong part .
  6. B

    Replacing air-con condensor Vectra C 1.8 petrol

    You should change the dryer as well due to the system being open (hole in condenser) moisture from atmosphere will damage dryer especially if faults been there a while.
  7. B

    Swivel mixer tap loose, but bolt is fully tightened...

    Remove the nut ,put a couple of washers on the thread then re fit nut . Get some one to hold the tap as you do up nut .That should do the trick
  8. B

    Ford taunus not starting

    Remove ht/coil lead from dizzy cap and place about 4mm from engine block/earth with ING on open and shut points by a small screwdriver, should see a spark at points and from coil lead to earth(be careful ht lead high voltage) if that's ok check brush in top of dizzy cap ,some rotor arms had a...
  9. B

    Advice on changing 9 pin connector on lighting fixure...

    HI You have a male connector the one you are looking at is female ,you need a nine pin male connector then you need to make sure that you wire it up to the correct pins on the connector.
  10. B

    There were two snails on a cable ...

    Are they using that cable as some kind of r AMP
  11. B

    There were two snails on a cable ...

    That picture was a "fluke"
  12. B

    There were two snails on a cable ...

    Watt are they doing
  13. B

    Continuity test

    If you haven't fitted the sockets in the 3rd bedroom yet(front plates not fitted) what is the set up of the wiring in that room . Without the sockets being fitted you will not have a final ring. Or am I reading this wrong ? Having continuality on N does does seem strange, and missing on L...
  14. B

    Vertical radiator - noisier than traditional ones?

    HI Most vertical rads must be plumbed the correct way around they have a baffle in side them, have you plumbed the flow to the correct side of the rad .It seems strange its making a noise now, but worth a look to see if flow is in correct end of rad.
  15. B

    "Consumer's Panel"

    What is wrong in an emergency to switch power of by main switch on cu ? it could stop a lot more damage to property or life's. Every body should now where the main cu switch is and how to use it, so in an emergency they can operate it correctly. Also there main stopcock for water as well, many...
  16. B

    Process of replacing all radiators

    HI If you have a F/E tank make sure that is cleaned before draining down.
  17. B

    Stand alone washing machine drainage

    Will this help. https://www.screwfix.com/p/floplast-washing-machine-trap-white-40mm/18640
  18. B

    Reverse acting thermostat

    Sorry but you DO need a thermal dump in case of power cuts or pump failure. I looked into this when I installed my log burner.
  19. B

    Fiat 500 Exhaust need replacing?

    Hi John ,no its built into the back box internally.Like you said just a basic venturi. The name pitot tube is used in many a design and ways .Like you said planes measuring out side pressures.We also had them fitted to auto gear boxes to measure internal pressures of fluids ect.
  20. B

    Fiat 500 Exhaust need replacing?

    HI thats correct Burnerman ,as the exhaust gas flows over the pitot tube it acts as a venturi. They are used all over. I worked for Rover for 30 years (some one had to lol)
Back
Top