Search results

Why is it that the setting options on the touchcenter are not the same as the keypad? Wheres my night set?

Yes... phone nfc would be awesome! Programming isn't easy on it either... certainly better off doing that on the old keypad. How do you go about activating the control elements? Cant see any threads on here about using em and as ever the manual's a bit pants

Hi folks! Any Touchcenter users on here?

Sound, cheers for that. Zone Programming: In relation to the 'Function' of each zone... is there a document somewhere that gives you details of intended functionality of each? Nothing in any of the manuals as far as I can see. 'Response Time' - Am I correct in thinking this is the delay...

Bit of an update... Sorted all my wiring, got the door bell causing a chime for the moment, ended up with this as 'Custom-A' - is this OK? I've fitted the ROI in the garage and an RF module in the panel. Since I needed a keypad for the garage I've moved the existing one to the garage and...

Thanks mate... I'll have a work though and let you know how I get on.

Wont wash as often as my missus then!

I know... tragic mate. I hate this kind of throw away culture.

Hotpoint say whole drum...

I'm planning how I'm going to extend the system and would like so feed back and/or pointers on how to configure the full and part sets. See below diagram with red existing infrastructure and blue planned new stuff. the only thing I haven't put on there are new reed contacts on the rear and...

Hi Folks! I have a Hotpoint WMAO963PUK washing machine and the bearings are on the way out... done a quick search for replacements but nothing conclusive... can anyone tell me if the bearings are replaceable and if so what I need to get in advance please? Cheers

Ok ok... menu 15... ‍♂️

So I'm not quite understanding something here or there is something not right... Z1 set to push set, chime active... yet no chime. Set Z2 to final and also turned chime on for this... no chime when door opened. What am I not doing/doing wrong?

Ah right that sounds perfect. Are there any general programming threads on here that you could point me in the direction of? Feel like I'm asking questions that may have been asked a thousand times before!?

Thanks Worth taking the doorbell off the system do you think? Will it activate a tone on the loud speakers as a 'push set'? It did this on the galaxy 16+. Is it possible to have it activate a tone on the loudspeakers without being used to set the alarm?

Cheers... all much of a muchness?

Hi folks... looking for recommendations for replacement / additional smoke detectors to wire into my honeywell security system please?

Sound thanks Galaxyguy! Leave the resistor on the board for that case? Can I check my door bell and door contact zone settings... I have doorbell function as 'final' and contact as 'exit' is that correct?

Have they got to be in essence in 1 line then as what I was thinking was using a current sensor cable to the garage to expand options in the garage with a 2nd ROI & keypad, but this would put the panel at the centre of a 'hub' of 3 chains - is this a no go? They have to all be in series as it...

New battery connected... system let me out of engineer mode normally :) I've also wired that little PCB back in what ever that does.