Search results

So... Taken the SAB connections off and powered the Hold... but I dont actually need to... the siren only sounds for a few seconds then dies... new battery needed in siren?

I'll flick open the ROI and have a look what's going on in there! Nice one - like you say keeps things tidy and saves a load of messing about!

So what's that do and where's it go to/from if it ain't wired into the panel!?

Sorry to keep after clarifications... see the terminal block... that has all the + & - wired to it. The + I get. The -'s... wire each one to the '0v' between the zones? So... Z3&4 for example... both red 12v to pin 12v Pir Z3 yellow to pin 3 Pir Z4 yellow to pin 4 Blue and black wires from...

Thanks buddy... definately 4 wire wiring atm.

Ah right... I get it... nice one. Does it actually matter which way round the sensor wires are wired (I.e. blue and yellow)? And 0v has to be wired to 'c' in your diagram or can that be 'c' or 'T'? Is it better practice in my situation to rewire each pir with c and 0v wired together or shall I...

Thanks GalaxyGuy! V helpful as ever! We can't set the alarm at the min because of the line fault and it not on monitoring. 3.1... so remove the resistors and wire as is... i.e. door bell to Z1? 3.3... so I can wire the + from the detectors to the nearest +12v on the board got it... but what...

Need 1 and 2 swapping over then, ta am I barking up the right tree with the SAB and keypad connections?

Looks like the Final and Exit Terminate maybe the other way round...? i.e. Z1 Hall PIR and Z2 E/T doorbell?

Hi all... right my panel is here and I want to make sure I'm prepared so as not to cause myself any issues regarding sirens, connections etc. I've tried to show what I am planning in the pic below - the top board is existing and the bottom the new. Some reconnections seem obvious (? lol)...

Thanks sparkymarka

Another quick Q (sorry)… connections 1 and 2 on the board are labelled 'E/T' and 'front door'... As far as I can figure 'front door' is the magnetic contact on the front door … go figure What is 'E/T'??? The doorbell sounds through the alarm's speakers... Is it that? ‍♂️

Sound... Presumably this wants to be the 1st thing done to prevent it going off while everything else is disconnected? Will the new panel put power through the SAB Hold by default when powered up before being programmed?

So connect the battery power to these wires currently connected to SAB Hold?

Cheers buddy! That's what I thought... he was a bit vague regarding condition but you've got to be in it to win it lol Looking forward to getting my hands on it. Is there a best way to take the old unit out? If I pull the mains then disconnect the battery will it not sound?

Found a 50+ unit on ebay… no reason not to go for the 50 is there?

Thanks GalaxyGuy... what modules do I need to make sure the panel has... is there a ethernet or wireless module or is it onboard?

Yeah cant get a fixed IP as I only have a 'residential' service. Are you saying I can 'selfmon' by paying them for there service to allow me to get alerts but I wont be able to use the GX control app from honeywell... or will selfmon allow me to use it?

Sorry C015-XX...

Brilliant, thanks GG... am I right in thinking that the honeywell app will need a fix IP address to function? And in terms of making sure I get the correct unit I'm looking for product ref C005-XX and will need the ethernet module? Does this require a cable to your router?