Search results

no, but the wires going to it are :roll:

test for continuity through the switch in both no/nc positions

if its not locking out i would be thinking the aps isn't making, have you tested with a multimeter?

if ya don't trust the bg lad wen he says it needs flushing why are ya planning on flushing it? if ya trust the independent rgi wen he says its just the rad valves why aren't ya just replacing them? just out of curiosity how much did he charge ya to come out and tell ya its the valves? i...

theres a thanks button :mrgreen:

underneath the boiler, should be a round hole cut out of the plastic electrics cover (its a red button)

does the boiler run n fire up? check the overheat hasn't tripped

looks like a old style pressure relief, the flow pipe will be the 1 that gets hot 1st wen ya put hw/ch on :mrgreen:

sounds to me like the aav is shot and its full of air

i was referring to what boiler shes got, the other bit i agree with. to add to the criticism to the people shes employed, i would also say the handyman doesn't sound very handy :lol:

have another read tony d means its trying to fire for hw (preheat). it might be airlocked, turn the stats down on the boiler n keep the ch on (on the timer/stat).

what happens wen you reset it?

means its overheated, have ya refilled to 1bar n pressed the rset button?

try this turn the power off at the fuse spur and remove batteries from stat turn the spur back on, press and hold both buttons on the receiver until ya see the red light flash. replace the batteries in the stat and check signal is being received by turning the stat up/down..

yes :lol:

its really a job for a rgi as the case to your boiler forms a seal and ya cant get to it without removing the case. where in sheff are ya?

so cynical :lol:

diverter valve motor could be stuck in the ch position

if i was doing the service id =visually check flue and prv =visually check condition of seals and heat exchanger =check op of heating/hot water (advise of any faults) =check burner pressure/gas rate =test op of any safety device's =check emissions using a flue gas analyser (strip n clean...

turn the power off at the fuse spur and remove batteries from stat turn the spur back on, press and hold both buttons on the receiver until ya see the red light flash. replace the batteries in the stat and check signal is being received by turning the stat up/down.. be quick iam off to the...