Search results

  1. L

    Chuffing Baxi Solo 2 Boiler

    HI is the pump overrun provided ?the pump should stay on for few minutes after the burner has been turned off to take the heat out from boiler. if this does not happen then pump will stop suddenly when the burner is turned off causing excessive heat to be trapped which causes loud noise...
  2. L

    water tank economy 7 thermostat

    HI depends where you live.how long the job is .
  3. L

    Help with my Baxi Conbi 105e boiler, please.

    HI sounds like two different faults pressure rising 1.expansion vessel faulty hot water problem common on these boilers hw diaphragm split/damaged
  4. L

    Push button toilet flush

    HI sink waste and flush not connected.flushing valve rubber seal worn or an object stuck which prevents complete seal and water over flowing into the pan.
  5. L

    Fitting thermostat to Saunier Duval F30e plus

    HI i hope you are registered/qualified for this.fit the room stat wires in the same terminals where the link was fitted.
  6. L

    Boiler somtimes fails to light ??

    HI need more details,and you might not get any reply/help due to make of the boiler as not many engineers install/repair these boilers. boiler not igniting can be caused by varios things eg,pressure switch fault,hw/ch sensor fault,p.c.b fault and more.
  7. L

    Problem with Ideal Isar HE24

    HI common fault on these boilers.diverter valve head becoming jammed.but better to carry out other checks first .
  8. L

    Oh no, new shower!!!

    HI keep the shower .retile the gaps.
  9. L

    Boiler outlet pipe

    HI simple solution.the boiler can be fitted with pluming kit (special flue) this will have air inlet in normal place but the outlet can be extended to a safe place away from doors /your window ,etc. FED UP OF COWBOYS ? TRY INDIANS
  10. L

    megatech unvented indirect solar cylinder

    HI i would think so.although not done solar panels but it is a common sense that the pipes are fitted to the right terminals.
  11. L

    Radiators not getting hot enough

    HI can be many things 1.radiators too small 2.house not insulated properly 3.boiler temp low 4.rads too old /crap in the system 5.gas supply low to the boiler 6.plus more
  12. L

    What's Happening Now?

    HI hard to think anything else at this time of the year.most likey frozen pipe somewhere.this can also happen inside the house.i have repaired many.
  13. L

    WHY DO I HAVE TO PUT CH & HW ON, ON MY TIMER FOR HOT WAT

    HI need more details of the system .
  14. L

    Repairing modern mixer tap?

    HI either the handle screws out or there is little screw at the rear ,top of the tap.use small allen key .remove top cap then access to the cartridge.
  15. L

    worcester 9.24 help

    HI Can be so many things . sensors ,heat exchanger ,,,,
  16. L

    Can a wet pump Brake a fan in the boiler

    HI can a blown car reverse bulb cause seat belt to get stuck ??
  17. L

    steam shower hot water prob

    HI 1.boiler diaphragm fault 2.shower mixer valve fault(cartridge)
  18. L

    STOP ENDS?

    HI sorry to reply after few months but what i meant was JG plastic stop ends that come off easily .other JG fittings are perfect never had any problems. just wanted to make clear.
Back
Top