Search results

1. Yes. U could have siren keypad and 2 wired zones. 2. Kit usually includes path dialler to text you if you wire a bt line in. Yes you can upgrade it to GSM. 3. Installed correctly it should not false alarm. 4. There is a very loud sounder in the panel itself. 5. Yes panel has keypad and...

Sound like a blown fuse inside panel. Are the detectors lighting up as you walk past?

Pyronix enforcer has facility for a wired siren and two wired zones. Pyronix are a manufacturer and you will need to go through a distributor for the products. This is a professional product not DIY

That does cross my mind a lot. A branded camera quite easily has "made in china" stuck on it somewhere :).

I second that and just as good as wired with many advantages.

Sorry did not explain that bit. They need to stay on a joist which is where I will be cutting them which leaves them protruding 6inches in to Hall. As I said someone has bricked up the doorway so the floorboards are supporting the brick. I think it will be a problem if nothing supports boards

Ii am going to put a floating laminate on top. The chipboard would lower the floor by a few mm to offset the floating floor as i did not want to raise the floor to much.

Hi I am removing all the floorboards in my hallway and will be fitting chipboard that is not quite as thick as the original Floorboards. This is fine as i intend to lay a floating floor over this. The problem i have is there used to be a door which has now been bricked up however this doorway...

Maybe...... After 25 years.....

U will then be dropping the power to the panel. Your siren may go off. Reinsert fuse after 30seconds and try your code

Remove battery. Hopefully you will have a fused spur near the main box (not the keypad there is a large white case somewhere containing your batteries and all the wiring.) lever the fuse out. If your not sure what you have don't attempt this.

Either way you will find out if it's any good always drop the power permanently if still an issue. Best do it daytime in case your bell sounds for a while

I would probably drop the power to it do a reboot first.

Sounds like it's waiting for a command do u have a no key or esc or even 0 may put it back to normal

Does it go off if you walk in to zone 2? Wondering if it's omitted that zone during set due to a fault.

At the risk of going off topic. I use the rpi with just a zwave adaptor plugged in to USB. Many zwave device/sensors out there. However still looking for some kind of zwave transmitter with multiple inputs to signal events from my alarm system... Ongoing

Nice.... I have similar using rpi and openhab.

Hi both are decent enough panels nothing between them really. However an LCD would be a lot easier to program and much more informative should you have a problem for a few extra pounds.

If you use an external wall then it can be drilled out anytime and a bt socket fitted. It's just saves fitting one later and if bt do it they will fit a big ugly pattress on the wall.

Can you not just fit a flush box and blank plate on an external wall just in case? Bt will normally wire round the house (from the outside) to wherever.... If u smile nicely