Search results

now back to flashing alerts

Would not remove the flashing alerts. Have tried to program from keypad2 (closest to computer at this point) and now says remote keypad locked out

Ok, so reconnected internal sounders and bell and entered the engineers code

Just looking up the default engineers code

Thanks for the encouragement. The keypad shows Zone 008 Tamper Area A - There is nothing connected to zone 8 - I have an 8XP fitted also and there is nothing connected to them. It also says battery fault and that is because I have not added the battery as I wanted it to stop when I removed...

If it is set to disarmed as standard then does that suggest I have wired it wrong? I followed the instructions from the others. will it tell me on the panel what is wrong? thanks

can live with it while programming if I have to. I would have thought it is set to disarmed as standard

my bad, it was then keypad! I have 2 keypads and they are wired to the same connections as per the earlier photo. I have set one of them to the switch 2 position. Can I shut off the keypad sound?

Ok, thanks Will try now

That's what I thought. I think it is set to sab. I will have another look now as I need to configure as it is getting late to keep the bell ringing..

I have connected the bell as per the Texecom instructions. That and the keypad are easy as there is only one way to connect them. After it started going off I removed all of the bell and internal sounder boxes connections so I don't know why it is going off. There is a jumper in the bell box...

Thanks all connected up and ready to program Only problem is bell is constantly going off when the power is on. I have disconnected the bell and internal sounders and it is still going off?? That does not make sense to me. I have not enabled the bells own battery yet? Any ideas as I need...

I am still wiring and will use the Wintex software to program via the com IP I have connected the internal sounders to Spk- and the + to the bell connection Think I am almost there, just don't want to damage the unit Thank you for sticking with me!!

Door contact Put black link from W to X and Y to Z Put black link across B Put black link across c Connect blue wire to outer connection screw 1 and yellow wire to outer connection screw 4 And then blue and yellow to a zone ? PIR Panel end your powered devices will have red and black for power...

Yes, as above Can you answer any of the other questions I posted to Sparkymarka? I think I did mean crate! Thanks

Owe you all a beer!

Last question! The panel and bell have a metal ring connecting a couple of terminals. Do these stay? Losing the will!!!

Thanks HandymanJo Does the go into the + terminal of the bell section or the one labelled bell. Thanks

Sparkymarka Just read your connection instructions and not sure which colours go into the zone terminals. Do the Blue and Yellow go in the zones? Red + √ Black - √ Blue and yellow eol of line √ Bosch pir , twist one leg of the 2.2 and 4.7 resistor together , put in NC in detector put the...

Sparkymarka Thanks for wiring instructions. I think I have it straight and will try tomorrow and see what happens... The Blue and Yellow are the ones that go in the zones in the panel. Where would I connect the Internal Sounder wires? Thanks