Search results

Yes cushioned vinyl I haven't no. I thought about putting that colourfill stuff can use on kitchen worktops over the dent/scratch.

Is there anyway of repairing/making less obvious a dent/scratch in black lino? Thanks

Do I need to cut the ends off new copper pipe with a pipe cutter before crimping. Or can I use it straight out of the bundle without trimming the ends?

Why do column radiators have baffles in them? I no you need to flow to the side with the baffle can anyone explain there function please

Yes it is realativley small. I know they heat via radiation. Hence why I thought over sizing the btu rating.

So you'd probably go with the double columns and maybe be a tad over sized. These radiators transfer heat via radiation not convention. So best of being abit over sized as opposed to standard convertor radiators?

I'm looking at swapping 2, 1100 wide by 500 heigh single panel converter radiators for two tower column radiators. The existing are about 890 watts each. The columns will be 440 wide 1800 heigh a single in those are 850watts. A double is 1250 watts. Would I be best of with the double column or...

This

Are prorad the same?

I just wanted to know of there decent quality.

Are prorad radiators the same as henrad?

Does anyone worry about putting plastic pipework in for central heating in the void below the floorboards downstairs with regards to mice or rats?

I dont think you can, it's a Screwfix valve but they dont seem to sell them. It's a toilet were you can't swap the valve without splitting the toilet and pan. Hence why I was hopeful I could service it.

Anyone know if you can get the washer for them. The one in the picture not sure whether I'll be able to twist it to get it off.

Looking at it I may need to buy a new valve to get the washer. Still alot easier then splitting the cistern and pan to swap it.

Thank you

Is this serviceable at all isn't shutting off properly? It doesn't shut of lets water over flow in to the pan. Then eventually shuts off. To swap the valve would have to split the cistern from pan as it's an ideal concealed one. Thanks

Do they usually do it without taking the cistern off? On this type of toilet?

Thanks yes it just depends if there is another room there to get a spanner in to tighten new and untighten the old fill valve.

To change the fill valve on thjs type of toilet do you have to remove the cistern?