Search results

Was going to go with the mcapline clicker bathwaste and basin

Push plug clicker?

Cable that operates by moving the overflow?

Which of these two is the preferred method the push down clicker waste for a bath or the type were you turn the overflow. Thanks

If fitting one of this on low pressure is it best not to fit the flow reducer?

Is it ok to stick plastic shower panelling in to plywood. I think it's water and boiler proof. I planned on priming the plywood with SBR bond

I'm not sure if it is would you be able to tell by seeing a picture of it?

I've been given 600mm wide shower panels to install in a 800mm shower enclosure. This is a bad idea as there will be a joint on each wall to make up to 800mm it's the wooden panels. I have before used the plastic stuff that comes in 2.4m x 1m lengths

Thanks then my timber uprights on the wall I should make at 400mm centres?

Thanks is it unlikely it could be anything wrong with the dimmer switch itself?

What's the best way of finding the joist when securing the top plate of a stud wall to the ceiling? Thanks

I'm having a problem with flickering lights on my dimmer switch tried new bulbs that are definitely dimmable and the problem is still the same. Any ideas could there be a fault with the switch itself and it's transformer?

Thanks yes was going to make the opening 805. From the finished backer boards

I have a stud wall to built for a 800mm shower so I kind of making a U. What size should I make the distance between the walls to fit a 800mm tray? 805mm? Thanks

Has anyone seen column radiators or black radiators that has around 1100mm in width. Sure I once saw some at 1090mm. Is to swap a radiator and can't alter the pipe work under the floor. Radiator in at the moment is 1130. So with a 1100 I could just use a radiator tail extension. Thanks

Can a tub of inhibitior go out of date have some fernox unopened in it's tube. Says on the tube is best/use before September 2023. It's stays in the system for years though.

If installing an outside tap. And fitting a internal double check valve. Do I need to do anything with the little nut on the check valve? I think it's for draining down the check valve if needed

Yes drawing really

Is there anywhere that will show the X dimensions of polypipe waste fittings.

How much would a plumber change to change a toilet syphon? Means removing the cistern.