Search results

I would speak to UU and request that they check their end. All your responsible for is the pipe in your boundary. However connecting back to the main could possibly incur charges to you if they find nothing wrong and you still want the work doing. But either way a 750ltr accumalutor should be...

How far is it to the stop tap outside?

An accumulator is better than a break tank. I'm saying that as in open vented/ sealed system. So you will have an open vented coil in and unvented hot water cylinder.

Registered gas installer mate.

4ltrs a min is pretty poor. Only way would be run a new pipe. Accumulator would be an ideal set up. Tie in with a wras pump. The wood burner would need to be on a open vented system. So if you went for an unvented cylinder it would have to be twin coiled. Nath

Gas turned on at the meter? Nath

What's your incoming mains flow and pressure during peak demands? Nathan

I'd recommend getting the pipe re-run. Nath

Yeah I would. It's not that hard to swap if it is the plate hex. But getting a breakdown engineer. He should be able to diagnos the fault. Nath

Cheap price yes. But before you say yes ask what boiler is to be used. Its all well and good saving cash on the install. Then forking out after the 2 year warranty runs out. As cheap boiler manufacturers make there money back through the price of parts.

Possibly scaled up plate heat exchanger.

which model?

Is the upstairs thermostat turned up? Do you know where your zone valves are located? Nathan

Parts are available for your boiler.

What part is required

Yes should be y plan. If you can identify the wired in the wiring centre then you should not have a problem. Nathan

You have wires in ch on hw on but no wire in hw off. Means your valve will sit mid position. And will only shut off when the stat is satisfied presuming its wired correctly upstairs. Nathan

I'm just over the Pennines if you get stuck with finding an installer! Nathan

What reason did he give to replacing the gas pipe? Also what light does it get upto before it fails to light? Nathan

Do you have another 2 wires for the L N? If so then depending on your boiler some boilers have a live out switch live in. As live out would go to A and switched live back to your boiler from B. another way is a loop so aslong as its in A/B. and some just have a live in. Nathan