Search results

Well as an indesit engineer which now own hotpint, ariston and creda I fit the same part in these appliance whether they are integrated or not.

The following is what has been happening to my mother-in law for over the last year. She had paid them the £122.69 they said they owed her from the second email but now they have called in a debt collection agency and are demanding £882.61. The complaints will not give us a name and will not...

I can't remember what this fault indicates but a common fault on this appliance is an open heater. Unplug appliance, tip it on it's side, remove base plate and meter it.

Well i can tell you that there is absolutely no difference apart from the front on all hotpoint, ariston, indesit and creda appliances. They only cost more because people will pay more for these appliances.

The following is what has been happening to my mother-in law for over the last year. She had paid them the £122.69 they said they owed her from the second email but now they have called in a debt collection agency and are demanding £882.61. The complaints will not give us a name and will not...

What can happen with this appliance is the board is faulty behind the display and it is constantly stuck on a program. It sounds like you need a new module.

Check the sump hose for blockages.

The error code F02 means - Motor jammed or tacho detached. You need to check wiring to motor, module and check the tacho. But generally when you get the 2 flashes you need to change the motor but you might get lucky and it could be a wire.

You need a new motor.

The first things to check are your on/off switch, door lock and wiring to motor. Forgot the tell you to check the support. A common fault with this model is the drum support splitting causing the drum to rub against the heater and then tripping. This is what you have to do. 1. empty drum...

Unplug appliance and check the the thermostats. You can find these by removing the heater cover at the rear. You will probably find one is open circuit. All you should need is new stats.

You remove the screws that hold on the outer door panel which you can see when you drop the door down.

There is an easy test which will let you know if it is the valve and if so which one it is, follow these steps. 1. Removed dispenser drawer and get a torch. 2. Turn on hot valve under sink and shine torch into dispenser to see if you see and drips. 3. Turn off hot valve. 4. Turn on...

It is quite east to replace these. You will need to take on to the shop as there are different sizes though. When buying them get 3 as the other one will also be damaged. Note the rotation of the one left and just drop and slide in the others the same way. Once you have done this check your pump...

What you have to do is remove the backplate and meter the heater. You will probably find it is open circuit. To get a new one you will have to take the original with you as there are different ones for this model.

It is unusual for the sump to block, i would put it onto a short fill, reset and then set program to drain but it should be ok.

The components which cause this error can be any of the following, heater, ntc, module and pressure switch.

As with most new appliance these days the hot supply is only for top up purposes. It only uses hot water when you are doing a large load eg towels and it detects a temperature drop. Other than this it does not fill from the hot so you do not need a hot fill.

There is an easy test which will let you know if it is the valve and if so which one it is, follow these steps. 1. Reconnect hoses. 2. Removed dispenser drawer and get a torch. 3. Turn on hot valve under sink and shine torch into dispenser to see if you see and drips. 4. Turn off hot...

This is fault F07 - heater relay stuck. The most common problem for this is the pressure switch sticking. This is the fix - unplug appliance from mains, remove top, disconnect pressure switch hose from switch, tap switch on tor weight a few times, refit hose, reassemble and test. If this does...