Search results

This is the fault code for your heater relay stuck. It is possibly a fault in either your pressure switch, heater or module. The most common fix for this is to follow these steps. Unplug appliance from mains, remove lid, disconnect pressure switch hose from switch, tap the pressure switch a few...

10 flashes - pressure switch not sensing correctly. Possible faulty pressure switch or module.

What you have to do is - Remove back panel, take off sump hose (black hose from drum to pump) clear any blockages or anything jamming the impeller (you can put in a screwdriver into the pump and see if impeller is free at this stage. If it is still not draining the most common culprit is a...

They can be quite pricey, but trust me you will not need to meter it as it is probably blown and you will see the tracks are gone. Make sure you note the condition of the wiring connectors on the board before you replace as sometimes these get destroyed and you will need to replace individual...

To reset the stat push a sewing needle into the hole at the centre of the stat until you hear a click.

Your pump is blocked

Dryer element relay not working, check connections on pressure switch and module.

It is a pretty simple operation, just make sure you note the way the spring is sitting when you split the door.

Your pump is blocked. Pull out applaince, tilt it back, remove kick plate, remove pump filter and check for blockages.

You module is faulty, needs a new one.

It is best to connect it to the hot water supply as it saves the appliance having to heat up the water by itself and thus saves mony.

7 flashed means the heater relay is stuck. Check wiring on heater by unpluging appliance and removing backplate.

Have you checked that the transit bolts have been removed from the back?

Remove soap drawer and check for any dripping at the back. If it is dripping turn off the hot valve under the sink and check to see if it is stilll dripping, if it is still dripping do the same with the cold fill and you can see what valve is letting by. Usually it is the hot valve and is caused...

Your hose is probably too low and is syphoning out, make sure hose is raised at back to at least the hight of the top of the inner drum.

Probably an open stat. On a rare occation the inlet valve is faulty and letting in too much water at start of drying cycle, it should let in 0.5l but sometimes let's in too much.

Unplug from mains, check power module and you will probably find it has blown.