Search results

Thank you for checking! I think the noise was there initially, not very sure. I would say it started before 20 minutes of running.

I think there is a leak and escaping gas is lighting up. I am not starting that boiler again. Is repair by a gas safe plumber possible?

My phone didn’t record the sound very well but here is a link. https://e.pcloud.link/publink/show?code=XZCFjUZAxWPJNNloB5vneu3nB2p2fKvSBX7 Is it ok to have a delay on the solenoid and lighting? Will it settle down?

My apologies, the term I saw was “vented central heating system”. Here is a picture.

I moved into a house which is heated by an old floor standing unvented gas boiler. When I light up the boiler, it makes a noise that is making me alarmed. It alternates between gas burning hum and a “blowing” sound, as if it was filling with gas. Is that normal? The control box is a Nova 820...

Yes it is a transformer for the LED panel and there’s a remote controlled switch off-screen on the left. The switch has held up, the transformer looks like it may have too. Thank you for all the replies !

The light fixture failed in a spectacular manner. See the disaster: I am scared to connect it again. My house has old wiring with old fuses no RCD. What could possibly have caused that? It’s the lighting circuit so may not be that risky but I would like to know what you think.

I contacted Domestic & General. There is no warranty on parts if the plan ended, only on repairs (while the plan is active). The same fault happened in March 2019, which is when I bought a service plan and got it repaired by replacing the PCB. I think I'm done with this machine, I will get a...

It does take in water. I don't want it to be the PCB, I had a service plan and ended it :cry:

The model number is RPD 9467 J. The program starts normally, except the drum does not rotate at all. After 10 minutes or so it shows F.01 The PCB was replaced recently through Hotpoint service. The lock indicator is showing up, so it's not a lock issue. The belt is fine I checked. The motor...

We decided to replace the two cut joists entirely. Hoping the plaster for the ceiling below won't fall if we proceed carefully.

Here is a new picture after some more clean-up:

Hello, I opened up the area which was originally a chimney then a cupboard in my room. It was part cemented part suspended ply, I want to reclaim the floor area. How do I close that so we can use it safely? The house was built end of 19th century. At the far end there is timber fixed to the...

Hello, A windows company is coming around for full windows replacement (not slip-ins). What should I be looking out for when they work? Some windows have sash boxes. Another is being extended full height. I requested wood boxing instead of PVC. Thanks!

I see, so the membrane does need to sag. I will just remove the rockwool and insert foam board insulation between joists with a 50mm air gap above. Hopefully that will allow the roof fabric to work correctly.

Hi KenGMac, Thank you for your response. All right I understand that the moist air and difference in temperature can cause condensation. I should specify though, this is not in the loft space. The roof slant belongs to a bedroom in the house extension. So I do not see a provision for adequate...

They are rafters. How can I prevent condensation behind the insulation?

I removed insulating wool that was between rafters for a few days. The upper side of the wool became wet, specially on the low end and closer to the window. There seems to be condensation along the membrane. Is that normal? Will it damage the rafters?

Cool thank you for the reply.

... and there were electrics works recently. This started a couple of days ago. The electrician came to install four new double sockets in a new bedroom. He used the cable going to the boiler. He added a junction box, and pulled two cables from there. One connects to two double sockets linked...