Search results

An unvented cyclinder - I have considered that, and not entirely dismissed it yet but it is the additional cost (as I understand it) that is holding me back - but then again maybe it is a false economy!!! Thanks for your reply

Tony Thanks for your reply. The technical information is much appreciated. I wrote a message here because I am assuming that a lot of plumbers/heating engineers answer the questions here and as such I infact think that plumbers/heating engineers know huge amounts about their trade...

Hi... Quick question regarding locating a combi boiler... I am in the process of designing a house with a utility room on the ground floor, which is in turn the ideal position for the boiler. However, the combi boiler is to feed a bath and shower on each of the two floors above, i.e. the...

Oilman - I assume when you say "bad joint" that you mean the main control board?

Hello... Diagnostic computer/device for combi-boilers? I am hoping to find out if there is a device that would help me troubleshoot a faulty combination boiler (Vokera Compact 24). The boiler heats up, hits error condition, (red light) cuts out and then fires up again, and so forth. The...

Hello... You have to take the front panel facia off of the boiler then on the right hand side of the boiler there are two pipes that bend into the side of the boiler - the one at the back is the cold water supply to the boiler - undo the compression nut (ensuring the cold water is isolated) and...

WOW - My DHW has been transformed!!!!! I now have hot water delivered at pressure - I thought my Combi fed shower was good before, now I'll need to install some structural steal beams to support the shower base under the pressure of the water from the shower head!!!!! Removing the flow...

So here is what might be a very dumb question!!!! When I remove the flow restrictor is it sufficient to isolate the boiler cold water supply with the hot water taps open to drain the DHW pipes or do I infact need to isolate and drain the entire central heating system as well? Thanks!!!!!

Flow valve is fully open - positioned at rear on far right underneath the boiler. Thanks again!

Wow - incredibly fast reply - is this an expensive item? Thanks for your help.

Hello... I have a Vokera Compact 24 Combi Boiler that I am having a couple of problems with... (1)Intermittent hot water then getting cold and then heating again, and so on.... - I suspect that this due to the secondary thermistor, however the real reason I write here just now is to do...