Search results

Perhaps your right steel, going back to the other side and talk to Ben, I miss him, may even buy him a pint.

Both your comments:So has the fire supply pipe been disconnected physically or not, ie capped off (not just turned off at the gas valve) completely and and a gas tightness test applied. :?: Or have you simply Mmmmmmm you tell me. :?

I did mention that if you see one of my original posts and was going to advise you of your course of action, until you became unreasonable to say the least when you "comment" on your risk assessment of a flue as in this case could be acceptable. You will notice throughout I have been specific...

steel, don't go there we will have to talk about catalytic converters n stuff. The man thinks all gas appliances are the same for Christ's sake. I can say that because I think I have been appointed gods spokesman or something like that because I am RGI. 8) I must admit being promoted from a...

:roll: :roll: :roll: :roll: :roll: :roll:

You are probably right steel better things to do which is why I don't usually cross the line, if you know what I mean.:wink: Because of his attitude I will persevere a little longer the bloke is a complete idiot of the first order that's for sure however others reading his posts might think...

Popcorn ready are you sitting comfortably. I suggest you obtain a copy of "The Gas Industry Unsafe Situations Procedure" GIUSP, Then read: Section 6.3 In its entirety and let me know what you think. This should have been carried out by your registered gas installer at the time of the visit as...

1) You are actually advocating that it would be alright to run the gas fire with the flue in that condition. Dangerous situation. :shock: Quote: 2) :? Are your gaps exempt from the law of physics however small and the loft hatch can be misaligned, gaps to neighbouring properties if...

Hi magiclintel, another two, GIUSP and RIDDOR. just to keep you up to speed when following this thread. :wink: GSIUR = The Gas Safety (Installation & Use) Regulations 1998 GSIUP = Gas Industry Unsafe Situations Procedure. RIDDOR = The Reporting of Injuries , Diseases and Dangerous...

Hi magiclintal, just for the curious as I know you are, do you know what HSAW stands for? :wink:

Hi magiclintel would you like to know what GSIUR is?

Apoplectic fit will read disappointing reply or I will at least try.

Are you sure on the above and still serious of your previous comments?

ID = Immediately dangerous. When an ID situation has been identified the appliance must be CAPPED off and disabled from further use until the situation is rectified and passed as safe to use by a RGI Registered Gas Installer.

Are you serious on the content of your last post?

Just to add to the above comment this is untrue, everyone has been very very lucky that's why most gas appliance have flues that directly terminate outside to atmosphere.

Inadequate fixings, always needs a minimum of two or more fixings for flue pipework (fulcrum come to mind). Difficult to see fittings are correct from photo though. The fittings and pipework should have the makers stickers on and usually not interchangeable with other makes. If its an...

A logic with a leak :shock: surely not?