Search results

Not sure what you done to reset it but try to press unlock button on the panel and enter your 4 digits code or default 1111.

I beleive you can use digicom outputs programmed as output group - zone - mimic. It is on page 73 of your manual.

Check 12V fuses first. Faulty batery doesnt affect to DС supply if 230AC presents but it is good idea to keep fresh bat in your panel.

Sounds like he is wrong person to deal :(. Ask him for engineer code or any good installer can crash the panel and reprogram.

Sorry to interfere Area Programming -> Arming Modes -> Area B Arm by: Timed Exit (3) or Instant (4)

Mains powered detectors are good choice for domestic application. Find with built in radio link so not to run hardwire link between. Note what such detectors are equipped with internal battery what needs to be replaced every 3-4 years. And yes, heat in kitchen, smoke in hallway and top of...

Hi, You existing/broken handset is Videx art 924. If you can find the same it will be easy to fit new handpart. The alternative is you buy new handset art 3011 and carefully replace whole unit, try not to shortcut wires )))

Can option b) or c) reset even locked engineer code?

Can't see reason to replace chip as manual doesn't say about to do reset to defaults When resetting the GardTec 800 Series to factory defaults several levels of resetting are available, these are:-a) Pressing 1, 9, YES, NO during initial power up will revert the Master Code and...

Are you sure it going to be good signal streight between panel and detectors in your house? This is main issue plus good quality wireless cost twice expencive when wired.

Yes, If you dont know engineer code. But note what you will default panel so it will need full reprogramming

Only use wireless where not possible to run wires at all. Otherwise wired system is the best solution