Search results

I have just purchased a kenwood KHC604 induction hob to replace my Samsung ceramic hob that has just died, the sockets behind the hob / oven are - hard wired for the hob plug / socket for the cooker both of these are linked to the switch above the work surface, I assume that I can just...

update - the power boost button is not working and if pressed will turn the shower off, this is also the area where the dim light is appearing

I have this shower which works fine, the potential issue is that when the shower is off there is a dim blue light coming from the on/off power boost area, this is very dim and only noticeable when the light is off, should I be concerned ? any ideas what could be causing this ?

this is well pushed up and the bolt goes through where the recess is

if its not up far enough then the bolt wouldn't go through would it ?

I have had a pull around this evening and should the anti roll have much movement ? when I pull it the drop links click both sides but is this just normal movement ? Surely this wouldn't cause a cluck when pulling away as this would more likely be ARB bushes wouldn't it ?

if it was the cv joint then I guess this would do this everytime and it doesn't everything is really tight I have replaced with new bolts and still the same so this isn't the issue nothing else has been touched and it was not there before, this is really confusing

as advised the wishbone comes with all new bushes intact, the bolts are very rusty and I have been advised that all 3 are stretch bolts, nothing else has been changed and the tracking has been done today as you can only adjust toe in or out on these cars, the only time this knocks is...

should I have changed the bolts as I understand they are stretch bolts ?

it was a complete wishbone with all bushes drive shaft nut not touched

I have just changed the OS wishbone on my 1997 ford fiesta and used the original bolts, Now the car " clunks " when pulling away quickly or breaking quickly Can anyone shed any advice ?

I already have the heat res paint though

so hammerite anti rust and then heat resistant black on top ?

I can do either process but just want it to be the best method hammerite would be easier I guess as this does not need a primer and the paint is thicker I can buy a high temp primer and use high temp paint also whats the best way to stop any rust coming back through ?

and enamel paint ? heat resistant paint is quite thin I want a satin black finish which hammerite don't do

is there a heat resistant primer ? If there isn't then the heat paint is useless isn't it ? Do I need heat resistant of will an enamel paint do ?

nope behind the bath

hi I painted by towel radiator last year applying the following process removed all original paint slight rust spots were sanded away all back to bare metal heat resistant paint applied a year on its starting to show signs of ware around the bar ends, I did not use a primer on the...

as i see it there is a bracket which bolts through the bulk head and the bar goes through the middle of this, this is where there is play, the movement is minimal but metal against metal

i looked at the bar from the pedal to the servo today and it does cluck around a bit, is this supposed to do this ?