Search results

Hi, I cannot seem to locate replacement carbon brushes for this model on any of the usual appliance spares sites. Can anyone help? Will a generic AEG carbon brush do, or does this model take something a bit different and unique? Many thanks, M xx

Hi John, Thanks for your advice. It is a very new machine, but it has been vibrating during the spin cycles due to an uneven floor. This may have accelerated bearing damage. I didn't check belt cord damage though, and will do this before trying anything else. m, x

The drum belt for this slipped off over the weekend even before the washing cycle. I reattached the belt to the main wheel on the drum, but noticed that it did not sit centrally after a couple of revolutions. It kept moving its way towards the drum, but stopped when about 2-3mm of the belt was...

Please could anyone let me know where I can get a replacement front door to the above washing machine. The glass on mine shattered by itself last night. Any help would be gratefully appreciated. michelle

Hi Zipper, Thanks for your reply. This makes sense, and I can't rule it out, so I'll take a look at the motor on the weekend. The smell is inversely proportional to spin speed/load, so I'm guessing it could be something else. The smell peaks mid-wash, during water heating. It is...

Thanks for your reply Leccy, Please could you let me know where the capacitor is located and whether it is part of the heater or the motor circuit. Thanks, mplar

Hi Leccy, Many thanks for your prompt reply. I haven't gone ito the machine yet, as it's really difficult to remove from the built-in kitchen. The smell is similar to melting insulation - so I'm discounting the possibility of a rubbing drivebelt. The smell peaks in the middle of the...

I recently replaced the brushes on the motor of my Exxcel 1200 express and this did the trick. 4 weeks on, though, and I am getting a burning rubber smell emanating from the back of the machine. If I'm not mistaken, the smell peaks during the water heating stage, and lessens during spinning...

Hi rocks1, Thanks for your post. Could you let me know where I can get new brushes for the Bosh morot. I have an Exxcel 1200 Express. Thanks again for your kind help! Michelle

Hi everyone, The spin cycle wouldn't work after a wash, but there was no water in the drum, suggesting the pump had removed most of it. The clothes were of course more wet than normal as there was no spin. I removed the filter and found lollipop sticks in there. Removed these and replaced the...