Search results

They didn't close any taps in the house at all. Went straight out to road mains turned it off then repaired the heat exchanger and pump. Halfway through he plumbed in a tap before the boiler to isolate the feed in so we had some cold water in the house for our baby? Then went to open the mains...

Both actually. Which is very strange!

Yes checked, that's fully open too

Had boiler repaired recently. They had to shut off the mains stopcock outside to do some repairs to the boiler, and since then the water pressure to the house has been abysmal. Ive been outside to check it's fully opened at the mains stopcock and yes it is. But the pressure is so low now. Any...

What does that mean? Do I need to just replace the contact?

Hi all, Pyronix euro 46 V10 self install. Been working fine for 1yr. Recently my full set, final exit stopped working. I'll set to leave the house. Sometimes when I close the front door (wired contact) the alarm won't set, might keep beeping, then I re-enter and close door it'll set. Then...

All working! Thanks :) happy bunny. I think it was the level set in engineer that did it. The fail timer was already at 60

Just made the changes will try in next 20 when we go up. Fingers crossed. Log just said 'set fail' nothing more

Thanks will try in the morning

What does that mean? Will check logs in morning

So managed to do all of these. Still having the same problem. Set B again tonight, silent countdown, walked upstairs within 10 seconds (have 30 sec count set). After 30 seconds, it starts beeping as it does as if I'd just entered after it was armed I.e. telling me I have to input code. Walked...

Have setup my euro46 panel. Full set A works well for me. I set alarm, choose A. Timer starts, if I open and close my final exit the timer stops, alarm sets and confirmation noise occurs. When I return open the front door, timer starts, I then have time to unset. The problem comes when I try...

Thanks will give it a try

In engineers?

Until now have been using the master manager code as my user code to set A and B. Have been into the master manager menu, added a new user now for someone staying with us. This person when inputting their code automatically arms, I've allowed it to set unset A and B, but it doesn't give an...

Think so, where do I double check?

Trying to fullset, have front door set as final exit. Put in user code, set for A. Said leave from final exit, the countdown started, left and then a full tone came after closing the door. But that full tone from the internal sounder won't stop. What have I done wrong?

Can't seem to find where it becomes specific for A or B

Is there anyway to have different volumes for setA and setB. For example when setting for Bbed I'd like it to just beep confirm rather than a loud countdown to wake the kids.

Thanks. Managed to find the standard wired sensors. Can't seem to figure out where the keypad zone (which is my front door contact) is. Does this need to be programmed in a different way?