Search results

Just as bad as joiners, 8x4 sheet of 6mm ply? Erm can I have 8 lengths of 4 by 2 2.4m long please lol

If you have only 1 water tank in the loft, you may have a primatic system. This means you will have to bleed the Central heating system to remove the air.

Well said dp

Why not run 15mm flow and return to were it drops down to feed the rad reduce to 8 or 10mm (10 I would recommend) that should give you enough flow rate to heat the rad.

Be careful not rip the plastic flap on the plunger this keeps the seal to allow siphonage. Could try blue tac? Lol

Lion08 if you can read up on the let-by test . It should tell you what you are testing thus why its 10 and tightness 20. Also consider what is and isn't permissable. The beat advice I can give if you still don't understand is to wait until you are doing death by PowerPoint, or ask the rgi you...

I'm not picking a arguement mate! Just got ma thinking and i hope the hammers don't go down showed real heart today. Just got me thinking that's all? For any club that goes down the financial implications are huge. With the hammers it's a bit different possible off loading to lower wage bill...

Do you think they will still get the Olympic stadium if they get relegated to championship football? Is there clauses on bid process? Can they afford it with the loss of revenue and such?

That pan looks like it's a siphonic trap I think?

Nor do we discriminate.... We hate everyone in equal measure. Unless you are paying then we like you until we get home or down the pub with mate when we begin the bitching again. :lol:

Have you tried to find the leak? You could check the compression nuts under the boiler were the boiler connects to the pipework. Use your hand but be careful these pipes maybe hot!!! If you find water trace it back to source this maybe in the boiler? If you don't feel confident enough then I'm...

I always keep some window trims in the van for this sort of thing. But the biggest I know is 100mm.

Hp, pardon my stupidity? But I was aware that if you linked multi prv's you needed to upgrade to next pipe size to carry the flow at 'worse case'. Idealy you would want them seperate. Or have I understood that wrong? Ps I can't see that pic too well so not even sure if it is multiple...

Is that a tee on the second floor I can see going into this copper pipe? If so this pipe seems undersized. Ie 3 prv's from 3 separate unvented systems (heating or hot water).

I would think that the mentioned leak is from the cold Mains pipe (to the boiler maybe). Hot water due to a reduce in flow of the cold(due to leak) over the plate heat exchanger. Cold rads at the bottom of rads could be sludge. Just my assumption. If you can hear the leak try turning the...

Did you mark and swap connectors correctly. More so the earth wires if it the new model of board. If the earths are not connected it will throw up a fault. Only mentioning this as I had a customer do a PCB DIY. Then got me out only to find earth not connected.

check if the pipe work is well surported/cliped?