Search results

Hi, Can someone tell me whether the flue in the picture has been terminated to standards please Regards

Hi, The problem was finally sorted after changing the flue. Thanks to all those who contributed

Anyone willing to help...I dont want to a buy a PCB and APS if they are fine

Hi, Checked Flue and all seems to be intact from within the bioler. The flue seal looks fine too. Its only broken from the outside and thats only the end cap. What I am seeing is that when the bioler has been on for say 10 minutes and its warm then opening the hot tap or turning CH on is...

Hi, Thanks for the response, I dont think the flue was assembled incorrectly as we havent had any problems with the boiler for over two years. The flue broke recently after a large metal sheet somehow hit the flue. I only noticed this as the front bit of the flue was on the floor and the...

Hi, Thanks for the responses. It looks as though the flue insert is loose which may be causing the problem whereby the boiler doesnt fire up. Can someone tell me how much im looking at for a flue repair/replace and a service please? Regards

Anyone out there willing to help.....

Hi all, Checked the external flue which seems to be broken as the insert moves freely and easitly pulls out. Would this cause the burner to ignite and go off and for this to repeat. I do get hot water and CH but this process can go on for a while. Also, will the flue just push in or is there...

I dont know if this is related to the problem but my external gutter has been leaking near the boiler flue. Rain water may have entered the flue

Hi, The bruner light come on but only stays on for about 5 seconds. It does this about 6 times and then stays on for a while and then the flue fault light comes on and then the process starts again

Hi, Thanks for the response. The fault light flashes and isnt continuously on. I turn on the hot tap and within 30 seconds the fault light starts flashing, about 30 seconds later the burner tries to ignite but goes off, this happens about 8 times and then finally the burner ignites and...

I also removed the clip holding switch housing on top and can see the pin move in and out.

Hi, I have replaced the assembly complete. Prt No. 248063 which has made a slight improvement in that water gets hot but after a long while. The fault light which indicates a fault on fan or flue comes on and then a few minutes later the burners ignite and I get hot water. I have also noticed...

Hi, Thanks for the response. Is it an easy replacement similar to changing the diaphragm? Regards

Hi, I am having the same problem again. Central heating works fine but not hot water both in the the kitchen or bathroom. The only way i get hot water is to turn the central heating on first. I changed the diaphragm about 3 months ago and that seemed to resolve the issue at the time. Any...

Yes alarm has been working fine. It only recently developed the fault whereby the tamper buzzer would sounce at intermitent times. The bell box is new so cant be that hence thought i would change the battery as its over 5 years old.

I paid £16.50 on Ebay :D

I purchased the 2.1Ah battery just to be on the safe side. Also noticed these ones are more expensive then the 2.2 and 2.3 version!

Hi, Went to Maplins but they only have the 12v 2.3Ah in stock. The current battery in the mains unit is 12v 2.1. Is there any major difference, i.e. will the 2.3 one do the same job or am i better of waiting until tomorrow and getting the 2.1Ah Thanks in advance

Cheers Davydunt. Do you take paypal payments? :P