Search results

if its 1 yr old then you should be under warranty as long as your installer has registered the blr and filled in the commissioning details. As you have'nt gone down the road of contacting baxi I'm thinking dodgy install?! :|

just to help decipher the above. Bayonet connections are a fitting that is exempt from the gas safety regulations in that you do not need to be a registered engineer to disconnect the hose from the bayonet fitting-as long as that is what you have got! You may not however attempt to remove the...

This appliance with that fault it's the aps 99% of the time. maybe even more.

it is. 1. get yellow pages or similar 2. find number of reputable REGISTERED GAS ENGINEER to access the combustion chamber of your boiler. 3. book an appointment with said qualified engineer who will come and do it for you and will CARRY OUT THE RELEVANT SAFETY CHECKS WHICH MUST ALSO BE...

Hello all. looking at increasing builders opening. I am happy about fitting a lintel at the the front, but the width of the opening would mean removing some of the cheeks on the inside of the opening. My concern is with regard to how much support these give to the internal stack, or is this...

thats a p155 poor diagram adl :wink: Just check you have'nt overtightened the fitting and cracked the female part of the wallplate.

amorous neighbours?

the fall is also to maintain a self cleaning velocity. Too fast and trap loss. to slow and suspended debris becomes just debris

something about grandmothers and sucking eggs comes to mind here

g.v would have shut off with stat harold

baxmax. go to lee robinsons head of class. gold star for commitment to the cause. brown nose :lol: nice to see so many people rating the baxis

do you have the tap type filling loop with the circular heads? Make sure you open the left hand valve fully, then the right as in the video. the non return valves can sometimes stick. a sharp bang with a spanner on the left hand valve can sometimes be enough just to free it. If your boilers...

had a really odd noise on occuring on the pcb on a solo being caused by what I think was a back voltage of a dodgy drayton or danfoss 3 way. caused a really odd boing noise on the board but only when the valve motor was moving over. btw turning stat down doesn't eliminate pump/circulation...

Oh goody, i can find out what the pro's actually are for ally heat ex's. please post.

ventialtion requirements have been updated and ARE retrospective. as for flue? post some pictures

been to some really poorly maintaned blr where PHJ were the service contractors tbh. 6 of one, half a dozen of the other really.

yes thanks all. I've eventually adjusted the doors up so that the gap between the top pf the doors and the frame head is only now 5mm. This has meant packing the wooden floor plate up by about 6-8mm but this still leaves a substantial gap between the bottom of the door and this. Moral of...

Theres also Northern Gas but......

Matt, if you're still after a fitter in wolves you could do far worse than to speak to Octoplumb. They fit worcester's but have been accredited fitter for at least the past 5 years. Good quality installers, very tidy and powerflush as part of price. Give em a call.

thanks LL and foxhole. The stanley trick worked wonders. Scored all the weay around and cut on both sides so no break out on the opposite side to cutting. Tried to finish with my hand plane but wood too hard, but the electric did the trick. Have to say though I'm not very chuffed with the...