Search results

Havent had good experiences with Baumatic,see if you can get a Flavel/Leisure/Rangemaster for the money-good machine easy for spares

back wall of fridge should frost up all over when running and should defrost when off on stat-not much diyer can do about this.Only thing diy can check is door shutting correctly,is internal light going off.Remove lamp for day or so this will rule out lamp coming on and raising temp of fridge

E90 =cycle blocked suggest check pump/drain etc

am assuming this machine has stainless steel outer tub(some have plastic) large torx screw is in centre of pulley for removal of pulley only.if you want to remove this youl have to heat with blowlamp-to change bearings tub needs to be lifted out of top of machine-not for diy suggest you scrap...

follow drain hose into machine-it attaches to pump-remove all hoses from pump check inside pump and associated hoses for coins etc.other end of drain hose check if blocked where pushed on under sink{check sink end first}

induction motor probably on this machine,no brushes.Possible faulty speed module,poss faulty capacitor-very difficult for diyer to diagnose without trying new components

Reset is below facia on left hand side,looks like a raised red cross marked on it

This has happened to me twice as a service engineer on this make of dishwasher-the only way i found was to force facia off and renew parts later

make sure you released new brushes from thier holders after fitting by bending up copper/brass tag-just a thought

follow the hose back to machine,it will be connected to the pump,take hoses off pump and check for obstruction in pump.

sounds like blocked outlet pump-most bosch have filters,check this for coin etc-drain machine first by dropping outlet hose into a bowl

E10 means water fill problem,in your case probably condenser solenoid/cold water feed

As mentioned drum speed seems ok,if clothes coming out wetter than when put in then check pumping out speed-possible partial blockage under sink or in pump,also possible condenser blocked with fluff.

Rinse aid has anti foaming ingredients,try pouring a capfull into machine before use.Another method is to try placing a bar of soap on upper basket and running machine.Both methods should be used under supervision in case foaming occurs.

On most simple programmers/auto timers,theres a live and neutral supply to run clock and a live/switch wire to feed oven.Identify live/neutral and join other two wires together(ie live/switchwire).

current call out for hotpoint is £92

machine will impulse straaight through heat pause if economy switch is selected-or if switch is faulty.

The machine will fill cold through both inlet valves and will then heat the water up.Downside-will take longer to do the wash/may cost slightly more to run(depending where boiler/cylinder situated).

Near to pump impellor (spined wheel) there is a black rubber non return valve,pull this out and water will run back from chamber on side of machine into dishwasher.This very often clears any blockage,then replace valve.If this fails this dishwasher is not one i would reccomend as a diy fix.Best...

Either the heater element is open circuit or toc open circuit.The heater is found by removing back panel-new heater looks slightly different to some older ones where they replaced thermal fuse with two stats.