Search results

Could be salt light-check salt level-if needed

WM range control knobs do just pull off if only 3/4 years old.

Sorry forgot to say stat does not reset itself-will need replacing if gone open circuit.

The condenser is a large plastic chamber that is fixed to back of outer tub,the top of condenser is fixed to metal heater box with 2 screws/nut bolts.....The dryer stat has 2 spade terminals and is held to top of heater box with a metal spring clip.It should have a number on it to advise on...

Are you sure about model number you gave, i know of WM61 but i thought WMA range only went up to WMA33 or thereabouts.Not being picky but these two machines are totally different.Ta Nige.

If flame lights in oven but stays low on burner then part likely to be faulty is Flame Failure Device(ffd) I dont know this oven but it will only have a thermocouple device if you manually have to hold stat knob in for 15 secs after lighting-hope this helps.

Yes could do.In a frost free during the defrost cycle heaters are turned on to clear ice/snow from evaporator.The evaporator(part that generates cold) may be as low as minus 25 deg celsius-when defrost heater is applied sudden warm up can make metal plate type covers etc bang/crack/groan.

if not condenser blocked,check dryer fan is turning-wire often breaks on fan,this then causes toc (overheat stat) on heater box to go open circuit.

ive had this in past,it was down to levelling/fixing of appliance-does dw leak if slid out of unit and levelled-best of luck MOD please see item 17

ive only posted a couple of replies if you do a search on my posts it should cure your problem

Breezer-i dont mind about no thanks,but took me ages to find this repair out so thought would share anyway ta nigeld

if no joy on checking on off switch-look at pcb/e prom situated at bottom left of m/c .ive had leaksfrom tub rear halves blowing pcbs quite a few times on these m/cs

the cure for this is to remove soap drawer,clean roof of outer soap drawer,dry and then wipe roof with a tissue that has been sprayed with wd40-believe it or not this lasts for about 6 months