Search results

i'm not too sure if there is a problem or not maybe just needs a little bedding in :?

do you know the bosch part numbers of both parts you purchased

if the back has a metal plate you can take off to expose the inner of the back and see the motor run it DO NOT TOUCH ANYWHERE NEAR IT have a look to see any tell tale signs for the smell

it will make a little bit of a different sound , the new brushes should be fitted with the angle at the correct fitting to the motor armature the 'buzzing' unlikely to be bearings

run the machine about 3 or 4 times and keep a close eye on water in the base if none collects then cancel good work well done :D :D

:D :idea: :D :idea: 8)

wow , that has gone pop does it have any AKO numbers on it

would somebody show a picture of these reed switches i believe they are megnetically controlled

ok great if pump is working thats the first part of the cycle , next step is for water to come in . aqua stop is where you screw it in under the sink http://www.casaparts.co.uk/products/id-26080929

this part is like a smart meter , your machine is a flexi load model give these people a call , i'm sure they have your part...

does this have any electrical attachments ,

check the brushes haven't stuck if not possibly motor dead or possibly PCB damage

first thing is to check the aqua stop inlet valve & the drain pump ALWAYS make sure power is off before you start. Always have a quick look in the basel for signs of a leak next is (power on again) switch on to a cold rinse setting listen for the drain pump , this is the part which...

undo the t20 screws down the sides and top of the inside of the door lower front panel will fall out , catch it or you might scratch it !! the facia panel then needs to be gently eased out a little ( many wires ) pcb now exposed , will have several multi pin connectors , take a photo of...

you have 1 of 3 possibilities could be something elese but is highly unlikely 1) faulty heating element 2) faulty thermostat 3) faulty PCB PCB is likely to show burnt tracks if faulty element can be tested with a meter tester , and can be accessed via removal of a side panel...

to check for a leak is straight forward, have a look in the base or tilt backwards as you said it would help if you could describe what happens after switching on. i.e does water enter etc etc

hi there divermoose if its the drain pump it will only sound when water is being flushed out , you will hear via the sink or drain pipe close by if its the circulation pump it will sound whilst all the spray arms are spinning - basically during a wash cycle you can try...

:D :D

could be a couple of things first try testing the hot water fill valve 1st , high pressure may have damaged it , thus no change since pressure changed.

keep off your soap box there fella this post is also there for future readers to follow tips camomile is recommended