Search results

ease out with a blunt instrument

Got a Britannia 90cm Range Cooker has gas burners and 2 electric ovens , very popular version of their cookers i believe as i have seen many is approx 10 years old or so, and has served us great no sign of any model number on the cooker anywhere the smaller oven on the right has developed...

there is obviously a bit something in there finding it will be a labour of love

I know the dome your mention , if its not full of fatty gunge then that is no worries everything else seems as it should so long as the black pressure switch is in its correct place & pipes too how come you found it works on a tilt is it level now

there is 2 pressure switches if i remember correct one by the motor housing http://www.casaparts.co.uk/products/id-26080908 the other has a thin black pipe which leads to it at the bottom front of the dishwashers front base http://www.casaparts.co.uk/products/id-23100912 check these ...

There you go hib always best to check things are fastened tight enough when putting back together hope you don't work at the tyre garage that puts the wheels back on my car :wink: :wink: chemical injection damp proofing seems like a nice life :roll: don't discriminate against women , i...

Its just a simple case of wear and tear mixed with a bit of bad luck lots of people would simply ditch a machine to landfill for this kind of problem . Good for you

Time for a new one of these http://www.casaparts.co.uk/products/id-05070917

Loose connection on the aqua stop is a possibility put machine on its back undo 4 screws that fasten the base pull out base being careful not to damage the flood sensor check connections from the aqua stop under here can work loose if the aqua stop has been pulled about or stretched, is a...

Check the Aqua Stop (water inlet) put machine on a universal wash machine will drain first for about 1 minute at the start then it will fill !!! at this stage put your hand on the aqua stop where it screws on to the water pipes under the sink and feel if it is buzzing or not i suspect it is...

if the float switch is activated , all you will hear is the pump running , or even switch left un plugged during repairs but switch will only be activated if polystyrene float is raised up by water or a piece of junk

rocks1 will know the answer to this :D

take it out of its place on the top by the door there will be 1 or 2 philips screws take off and door will pull open check the door refit the catch

could be one of the hoses which run from the sump to the drain pump. check for a blockage also is the pump wired in ok (2 wires)

possibly pcb which model is it

pcb probably gone which model is it

if you have the lid and the 2 sides removed flick the springs out of the underside of the base make sure the 4 t20 screws removed which hold the plastic base to the tub i ususally then put it upside down on its lid take a picture of the wires or make a note the casing to the heating...

1 month old !! needs to go back for another one .

when you switch on where does it get to drain pump ? water filling ? motor running ?

would seem the heater or thermostat has failed looks like this http://www.casaparts.co.uk/products/id-25080927 http://www.casaparts.co.uk/products/id-25080903