Search results

I was seeing the 50mm bath traps with the anti syphon on them so thought of the standalone version. The bath waste I have includeds the trap and the fitting comes off level with the floor. I do plan on separating the bath waste after I start on the toilet, instead of a 90deg bend going up to...

Can I fit this straight off of my bath trap? (McAlpine HC2650UK)

My shower waste (all pipework is in the garage below at ceiling height) is on a pretty long run, nearer the stack the bath Tees into it waste, when the bath drains I get the suction going to the shower trap. Can I fit one of these in-between the shower & bath wastes or do these need to be above...

If your computer is working fine, just keep using it with win 10

Do you have a Hotmail or outlook email address? They have the online version of office to use for free

lol

Just an update, got the correct leg set from VP delivered this noon

Can only speak to VP through live chat, got it sorted out with the guy I spoke to this morning, I should have the leg set tomorrow. Cheers for all the replies

Looks like it could be a cradle, do you get them that fit into the black plastic bits attached under the bath rim? There's 4 of them each inline with where it's marked to fix the feet bar

Not opening fully, but what I did open there's nothing apart from the fiberglass panel & the wee box with the panel clips

Shows you where to fix the feet bar to

Bath panel

here's photes

https://www.victorianplumbing.co.uk/cleargreen-viride-offset-170cm-x-75cm-single-ended-bath-with-panel

Just got a bath delivered and it's came with no feet. Looked on the site and there's no mention that it didn't come with feet. Looked on a different site and it says floor standing/floor mounted. It's a J shaped bath with a bath panel. (Cleargreen Viride offset bath) Is this becoming normal...

Cheers, 1 tap is outside and the other is just inside the garage door, both have gate vales to shut them off for winter. I'll add the check valve after this and also add in a drain cock. Cheers

I have 2 outside taps, but they don't have any check valves on them, where's the best location to fit the check valve? Just after the tee from the main pipework or nearer the tap

Forget it, it was me being stupid! I just cracked open the stopcock so the open taps wouldn't run fast.....

In fact, the cold is doing it as well

If I leave it for a while there is some pressure but after the tap has ran for 30 seconds it starts to drop flow rate to slow