Search results

I was wondering if someone could help, i'm after some ducting to put in floor slab to take new water main, found this https://www.drainagesuperstore.co.uk/product/underground-water-ducting-coil-63mm-x-50m-blue.html but 50m really only need about 15-20m, is anything else suitable

I'll run that where the doorway is so no pipes under

Ok Thanks.

If I want a stud wall to create a hallway how do i fix to floor in following situation? Concrete floor covered with 100mm celotex and 50mm screed? Would the screed be enough to fix to if i had a doorway in this stud wall?

Must admit would prefer wood to tiles, appreciate they are warmer to start with just concerned about the insulation effect for warming the room. Ideally need to find someone that has both.

Interesting, might be an option, thought these were all ceramic and i have seen them after several years with no pattern left.

Will be installing wet UFH with an anhydrite screed. Will finishing with engineered wood floor impact the ufh getting into the room to any great extent? Really not sure how to finish the floor. This will be a lounge and kitchen

ignore

My programmer thought my temp set point was 19 degrees, so kept shutting down at that despite stat being higher, now perfect. Should have been bound from new, only a few weeks old

Sussed it. The programmer was not binded to stat, now solved

This is where I think i have a fault with my programmer/stat. In manual it says Enquiry Mode As the heart of your system, the ST9420C has access to temperature information from the other system components, and allows you to enquire about this information If i go into this it tells me Room temp...

Thanks for your help, much appreciated!

Hopefully you can answer this then? In DT92E manual it says Proportional band width 1.5 to 3 deg c also Cycle rate 3, 6, 9, 12 I'm on default 1.5 and 6 Just wondering what that means. Hopefully move to a Evohome in near future Also has Temperature measurement offset -3 to 3 K i''m on 0

I see, Thank you

Ok I will try. Hot water set to on from 6.00 am to 10 pm and green light remains on, on the programmer during this period. Heating set from 6.00 pm to 10 pm but green light goes on and off about 5 minutes after room stat goes off (required temp) Is this correct, why does heating light go off but...

Checking Today, the lights on programmer has hot water light on all the time programmer has it set to on, but heating green light switches off even though set to run and set on programmer when stat set at 17.5 gets to 18.5, just confusing me what is going on, why is hot water light always on but...

Thanks, so it looks like mine is not OpenTherm compatible worcester 30 cdi regular therefore does this mean an Evohome system is only usable for zoning and HW. with the BDR91 instead of R8810A1018 Wireless OpenTherm Bridge R8810 Think I understand even if it appears i don't ;)

Or is it a case of getting a Honeywell R8810A1018 Wireless OpenTherm Bridge R8810 connecting to boiler, would this be paired with the DT92E and the ST9420C as it says compatible with evohome (all versions), CMS927, DTS92E, T87RF and RF2 Pack 3, and i have rf2 pack 2?

so the DT92E is opentherm but the ST9420C is not? So if i changed eventually to the evohome with a BDR wireless relay box, that would be?

Using above system, My stat stays on 19 degrees and flame symbol shows (call for heat) all the time even though boiler is not on all the time. Is this correct, i keep thinking boiler is on when it's not? why have the flame symbol on the DT92E if it works this way.