Search results

Probably blocked access is usually below filters by removing the t20 screw and lifting out the inspection chamber.

you may have a leaking seal usually the one by the circo motor (front right) or if the water was clear in the base look at rear inlet valve(back left)

Base is full of water activating anti flood or pressure chamber is blocked. Remove left side panel to inspect.

is it constantly pumping or is it just not filling?

is it filling with water. If not check the drain pump is not blocked as it sounds a pump problem

not all cookers need to be run on its own circuit as it depends on the rating of the oven.i.e if it is below 13amps then it can be plugged in.

Magnetron faulty.

Set to off, turn 1 step to the right (clockwise),Then hold wash plus and whilst still holding this turn again 1 step to the right, this will then enable you to adjust button signals, once adjusted press finish i to store, to set info volume step again 1 to the right and then you set this press...

Take the casing of and you will see 2 screws at the top of the facia undo these,thus releasing the facia unclip all wires and the facia will come off. Then it is a case of undoing the screws

The model number found on the door

If you use official Neff repair you get a 12 month guarantee with the part they replace.It will cost you more 70 quid call out plus part but it may be worth it.

If you press the temp setting on the microwave does this illuminate how many mins to run i.e if 900 pressed does 1 min show. If not you can not replace a light the whole display needs replacing.Approx £120 + vat

Are you buying official authentic parts? I find it hard to believe there was a problem with the stat as having worked on these appliances for several years i have yet to change a stat for failure!What are you cleaning the oven with?

You need to post the e-nr number

Neff are probably one of the best money can buy, you only get negative feedback from the odd disgruntled person compared to the thousands and thousands of satisfied customers.As you can see from the posting before this because he has had problems he thinks they are all like his but don't go and...

Its not the button but the whole switch that needs removing.Look at the switch from inside and you see a small plastic tab at the top of it all you do is prise that away from the metal and slide the switch upwards.

Just take your e-nr number to parts supplier and they will fix you up. it will most probably be the element but if it is not you will find that the stat connector behind the front panel has burnt/arced.

These appliances are prone to pump problems but i would check that the hoses are clear first and not got a 5pence trapped and acting as a valve.

Pressure chamber float stuck?

You need to remove the lid and then access to on/off switch is from behind. Easy to swap for new one just clicks into place.