Search results

Anyone?

Isolate the power to the alarm, take off the lid, disconnect the battery. Then put a link (piece of wire) between the terminals listed below where it says factory fitted links. This will link out all the tamper protection. If this resolves the issue you can then remove them one at a time to find...

Hi all, I am looking to paint a previously varnished fireplace surround - Its removed from the wall so quite easy to work on. I think I need to sand it, prime it, sand it, undercoat it, sand it paint it, sand it, paint it. Is that correct? I am unsure on what type of primer and which...

Done exactly as you said above and all is now working fine. Thank you for all your help. (y)

Ok, after powering everything off and on the Hive is now working but with the thermostat still in place. Thanks for the help so far. Looks like it has 4 wires, not sure which 2 to connect?

Ok, so I have changed the wires from 2 to 1 and 4 to 3, I've left the thermostat in and turn on for now. When I turn the heating on with the Hive the thermostat lights up as if it's turning the heating on but it never comes on. Here is the photos of inside the thermostat -

Thank you, I'll give it ago later and post back.

Yes correct its the single channel version, so I need to swap 2 to 1 and 4 to 3? Thanks for your help.

Thanks for the detailed reply. I think I will go with option 1 as all the cables are actually hidden behind a unit and won't be seen. I'll let you know how I get on, its a Robus RRF10 thermostat. Am I right in thinking the Hive can just slot onto the exisiting programmer backplate with the...

No I wasn't planning on doing so, I didn't think I would need to touch the boiler?

Hi all, Lurk and read a lot on here but only signed up today. I am looking to replace my current Siemens RWB27 programmer and Robus thermostat with a Hive v2. I have a Greenstar 30si boiler. They both appear to have the same back plate so I'm hoping to just slot the Hive onto the existing...