Search results

Be VERY careful with the food, it tends to start to defrost overnight and refreeze in the day so not too good. There have been modifications where you put an external thermostat, in a box, set at approx 8c and wire it to the bulb in the fridge, when the ambient temp. drops the light came on...

I agree, wouldn't spend on pcb, but I doubt it is that. Your post on 25th Jan said it worked once, even though not through full prog. unusual for pcb fault. Make sure the transfer hose is clear, bottle brush, piece of cloth tied onto a rod. When you have done that turn machine on, with...

Does it heat the water? if not check the wires on the heater, and in the door. Don't know model but there may be a "cut out" on the heater. Good luck Colin

Quick test, carefully pull off the tube from the pressure switch and see if will fill/spin. Follow the small tube down from the pressure switch, water level switch, and see if it is blocked where it fits onto the pressure chamber. The machine will not fill if it thinks it's full. will not...

Or you could try these people, have used before and found good. http://www.qer.biz/servReps.htm Colin

Probably the temperature in the room so the new one will do the same! I would buy an Electrolux, Zaunnusi, Tricity, AEG, which ever was cheapest as main parts are all the same and as good as it gets these days! You will NEVER buy anything as good as you have got! Hotpoint, don't you mean...

You would need to put heat inside the fridge. A lot of fridges have a heater on the evaporator, if yours has and it's ok you could fit another, close to where the thermostat fixes to evaporator. If your evaporator is in the rear wall of fridge I have fitted a freezer stat to the freezer so it...

Check the new bulb? Colin

Yes Ok as you described BUT I would definitley secure with a bit of angle iron or at the least a chain at the back to stop it falling on top of someone when they fall against the door and pull it off! Colin

Are you sure that you have cleaned the grey corrugated hose from the left hand side to the sump properly. I just take of L/H side pull out hose with O ring on push a bottle brush as far as it will go and that usually works! Had one recently exact same symptoms! Good luck Colin Sorry to butt in

Model is M96.28SM/C2 just over three years old, installed as complete new system. It had some sort of flushing? solution put in when installed then drained, then some inhibiter. Thanks Colin

Hi, I have Biasi Riva Compact He that is over-heating on dhw and then shutting down. CH working OK. On calling for hot water the boiler fires, water flow rate is normal but tepid at tap, the temperature gauge rises to just under 90c the boiler shuts down, temperature goes up to 95c pressure...