Search results

JOhn, OP said it doesnt stop when they manually lift the valve. Rico

Hi there, On your picture you have said its split is that right ? If not, isolate the water to the fill valve. Undo the big blue nut and check the washer, its either split or has some grit stuck in it. Rico

Hi there, Your system just need balancing correctly, check out the faqs. Seems that your installer was lazy arse and didnt do it. See if you can get him back to do it (for free) Rico

Hi there, How is the water supplied to your basin, mains or from a tank in the loft. If from tank in the loft, then check out the ball valve in your cold water tank, washer maybe on the way out making it vibrate when refilling. If all is mains pressure then could jumper in tap if...

HI there, Is the cold mans fed, if so it could be pushing its way back up to hot feed. Do you know if there any check valves fitted, if not fit one on the hot supply. Rico

Hi there, Get youself a strap on boss Rico

Hi there, In what way does the bottle trap not reach. Do you mean heightwise. If so go to plumbers merchant and get yourself and adjustable p-trap. Rico

Hi there, Use a ring spanner to reduce slipping. Give it gentle taps with a hammer, try tightening it a bit first. Failing that see if you can get your hands on a blow torch and heat it up a bit. Rico

Expansion vessel fooked

Col, See link, currently on trial with Lambeth Council http://news.bbc.co.uk/1/hi/england/london/8440931.stm Rico

for the f&e tank

It depends on what type of system you have. If open vented you can buy a bung kit from B&Q Rico

Hi there fella, Not always good to hi-jack a thread, not good etiquette, especially when the thread you hi-jack is 3 YEARS OLD. Post again under a new subject. Rico

Hi there, Has this come out of the middle of the bleed valve. The kind that is screwed into then end of the rad, or is that one that is "part" of the rad. If the former, would be easier just to change the whole bleed valve. Rico

Col, Yes you can recall an e-mail, providing the receipiant has read the original e-mail. Rico

Is there a room next door to the wall the washer will be on. If so could you not drill hole thru to next room and feed power cable into there and then plug in. Rico

Hi there, I think it should be set at around 5c and yes it will circultae the water even if programmer is set to off. Rico

Failing that I'll pop up and keep you warm, lol

:D

Hi there, Go outside and isung either a hair dryer or kettles of boiling water defrost the condensate pipe. Rico