Search results

Sorry, don't understand.

Bingo, managed to get swan kneck off !! Not sure if these washers are now square because they are so compressed. What type of washers do these look like or normally take ?? -circular side O-ring -square sided O-ring Are these standard washers you get at diy store or...

Ok, my boiler is finally working perfectly !! Has fired up every time for last 3 weeks. Changed: -both microswitches (DHW & Flow), -DHW Diaphragm & Stuffing Nut, -lubed all pins with silicone grease (DHW, Flow, Diverter), -straightened kink in one of tubes to Air Pressure Differential...

Pressure is holding ok. Thanks

I'll post a picture with it lovely & shiny. :D Tap cleaned up, lovely & shiny. :D

I've tried pullng spout out, with no success, will have another go. It hasn't budged so far. That'll just cleanup. The water supply is shared with flat above & I don't have separate supply stop cock or isolation valves for this tap, if I take time or is other problem if I changed tap.

Here's a picture of the mixer tap:

I still haven't found how to get the swan neck off, try as I might It must be simple, but how. Does the swan neck always come off ??

Ok. I thought the hole was always open, as hole is at top of plastic cap. Have tightened up to close.

The plastic cap has small holes in it, I assume to let the air out.

My Auto Air Vent Bottle seems to be dripping a bit too much water from the cap. Whenever I look, there is a small amount of water there. I'd like to change it. Looking at picture below, I see there is a Hex shape at its base to turn it I presume. The bottle is screwed in to the pump up...

Replaced plastic bit of safety valve. That worked a treat !! Old plastic bit came off nice & easy. Dripping has stopped & system is holding pressure. Thanks

Does it just unscrew ??

Does this usually work ?? How much do you heat ?? I've read to heat just the outer fitting to red heat so it expands, not to heat inner fitting as that could make it more difficult.