Search results

ok ha ha will do it now

Hi Davey, Sorry just back in I tried the wire trick you said and still no good I have left the clock off in case but can put it all back if needed.

No luck with the heating the water seems fine but cant get the heating to work 2 rads are very luke warm but nothing else on. If I can just get it back to heat while waiting for the controller to turn up that would be good.

I didnt see the message above you quoted so will go over that and try. Thanks for the reply

sorry even the Y on the PC keyboard has stuck should be any ideas

Dave, Since i freed the valve and took the controller off the wall i dont have any heating an ideas

Thanks will do yes camera at the ready.

Thanks yes knew it was a 2 channel one I wanted and will look at the range. Thanks for all the help dont know how much it would have cost if had someone in.

ignore my last post the heating didn't come on when i wired behind the panel ? the pump started but nothing happened. I think I just need to replace the controller as noted the date installed 1996. I have put everything back as normal and will get the controller during the week. One possible...

I am a bit confused : I have done the below and valve was very stiff to start and then moved it and now very loose. Put everything back set it to water constant and both sides of valve were hot even after 10 mins but rads did not get hot. Does that mean the valve part is fixed ? After...

Yes thanks safety first

I was waiting for the timer to come on and had the heating set to timed and water timed but cyl stat on 0 heating came on ok when expected. Testing your suggestion above : water on constant and heat on timed ( re setting the clock so time setting would come on in a few hours) water has heated...

Thanks for the help so far, I did check all the wires in the junction box all still connected. hw & ch constant, cylinder stat down. room stat now switch boiler on. Now I turn the room stat back down and after 5 min turns off pump. Have now noticed the valve is still in the H pos and the...

yes pipe to heating was hot sorry, valve stayed on W didn't move from last time.. Didnt move to CH. testing the HW and CH putting both on constant. cly stat down and room stat down turning the room stat up valve moved to Heat and pump kicked in. But turning the HW and CH back onto timed ( due to...

Thanks Davey I have tested the above here are the answers Switching power at spur off pump stops switch back on pump still stopped valve has moved to W W on, ch off. pump & boiler run, valve to W yes correct but pipe to boiler hot W on, ch on, r/stat turned up, pump & boiler run, valve to mid...

Davey, Right could not get timer face off removed bottom screw and it had two lugs at the top that i could not get depressed but this is the first time i have switched it off at the spur. I usually just switch off the boiler. when i turned it back on at the spur and put water from off to...

Stem I dont know if a frost thermostat is installed

I have now turned the water on constant at the timer and the indicator didnt move stayed in the mid pos M, putting the heating on constant same thing stayed on M. What does that mean. I have not done the timeclock bit as had to have power on to test the first part. Are you saying i need to...

Daveydub, I have turned everything off at timer ; water off and heating off.the stat on the water cylinder i turned down to 0 so that should not come on and now turning the boiler back on ( that was the only way i could get the heating to go off in the evening ) the pump has started so does that...

Thanks for the replies i will try that today and get back to you.