Search results

Thank you Gazman 16 sorry for my slow reply, found your reply in my junk mail. When I removed the rotten wood it damaged a cement fillet directly above the damp proof course. I have removed the cement which leaves enough space to fit driveway blocks, so this is what I have done. Cemented the...

I have a UPVC double glazed patio door which for some strange reason has wood underneath the frame. The wood has rotten away & I have removed it, supporting the window temporarily on small blocks of wood. It has been suggested that I should replace the wood with plastic, but where can I purchase...

I could fit it in the airing cupboard next to the programmer, but I would prefer to fit it where original is because it is in the middle of my bungalow for good reception also I would't have to fill a hole in the wall. The earth wire is effectively bare with only a short length of green/yellow...

I am still trying to fit the new stat in the same location as the original. I need to replace the existing 3 core + earth as I can not use the earth as a live. Where can I get 4 core cable bearing in mind that it has to run through the loft space. Guess it must be cable not flex. Boiler manual...

The cable is not round 4 core cable, so I will replace the cable with new round 4 core cable. I can then pick up a permanent supply from terminal 1 on the Sundial Y plan 10 pin connector block which also supplies the ST6400 programmer. Thank you ounce again D_Hailsham

If it treats a loss of power as an error & keeps searching for the receiver, I assume this will drain the batteries quickly? The green/yellow wire is currently an earth which is not needed, but as it is an earth I am reluctant to rewire it as a live. Is it ok to do that?

Thanks D_Hailsham for getting back to me. There are 4 wires to the T6360B Red, Blue, Yellow & Green/Yellow. Yes it does say that in the manual, but the Salus RT300RF is not a programmer with a clock so I don't see why it needs a permanent connection, otherwise what will happen if there is a...

Found a video on the Salus website that shows installation of link lead between terminals 2 & 3

I would like to replace my Honeywell T6360B room thermostat with a Salus RT300RF wireless thermostat. I would like to fit the Salus thermostat inplace of the Honeywell (fitted to hall wall) in the same location. The Honeywell has a switched live to control the boiler on pin 3 yellow wire, can...