Search results

I'm sorry I didn't mention this initially. The answer is no, when the alarm activates when the alarm hasn't been armed the bell box doesn't ring... only the internal sounder rings.

No, we're getting false alarms on Z3, Z6 24 Hr whether the alarm is armed or disarmed.

I do have a multimeter yeah. From the control panel Z3 is the furthest away, followed by Z4, then Z6 and then Z2. I'm intrigued as to what are you thinking next?

Yes, there's the following: Z1 door sensor Z2 PIR Z3 PIR Z4 shock sensor Z5 door sensor Z6 PIR Z7 PA Z8 PA And the bell box outside I don't think the door sensors and PAs use much power though do they?

Many of my friends who are in non-cabled areas have good things to say about Plusnet HTH

I'd give this a go and see where it gets you. Seems there are ways to reset MS Edge.

Thanks for all the replies. Cheers HMJ, I'll keep this in mind when I get chance to take another good look at it. Z3 is a PIR as is Z6. The bell box has been there since before I bought this house in Sep 2007. I'll try and get a picture of it. Old as in I think I may have seen Texecom 1996...

I have been having a nightmare with my house alarm these past few months. Randomly through the day or night the alarm will activate with either zone 3, 6 or 24 Hrs showing when I go to reset the alarm. This happens when the alarm is armed or disarmed. So far I have: Walk test and discovered...

Sorry for the late response on this. I took the dv assembly apart only to find that the pin had jammed somehow. There was nothing wrong with the diaphragm until I tried to peel it off the front brass cover to reveal the pin and spring assembly inside which made a slight tear around the outside...

Thanks for your response Agile... I'll get the valve assembly cracked open sometime over this weekend

Don't forget wheel alignment...

Yeah, generally the shoulder of a tyre is out of bounds for repair. Such a shame!

Hi there, I'm not getting any hot water from the boiler. It happened over the Christmas period and in early January I replaced the diaphragm which was in bad condition (holes and splits everywhere). However, now it's happening again but it's stopped in a matter of three days rather than over a...

The DV is a BGMVSP-23. I did get it working eventually but didn't want to post back until I confirmed it was working a few days later. I turned it off again (the electrics) and pushed a button in at the side which somehow allowed me to move the lever upto W. Turned the electrics back on and it...

Hey, thanks for replying The lever on the DV hasn't moved after turning off power.

Hi there, please could someone help? I'm trying to solve a problem for my parents. Currently, we can't seem to get any hot water but heating comes on no problem. When I call for hot water on the controller (an EMP2) I can hear the pump whirring. The little lever/indicator on the side of the DV...

Ok thanks newboy, I'll look into that one.

We have removed a Designa electric shower to install a Triton fast-fit. When undoing the pipework for the old shower I found that the cold water pipe sprung forwards further out of the hole in the wall by an inch. I'm not sure which wall fixings to use to fasten the new shower to the wall...

Sounds to me like a dry contact in the circuitry of the monitor. When the monitor goes black do get a very faint silhouette of what was on the screen prior to it going black? Possibly dry contact affected by heat on power to the backlight.

I forgot to add that I have also checked that there is enough water pressure.