Search results

When the system refilled its possible air got trapped in the pipes. Sometimes varying the pump speed can dislodge an air lock.

Hi Sounds like you may have an air lock. Turn off the rads that work and see if the others warm up.

Hi After you 've checked the filters on the shower. I'd have the neck of the hot water tank off to be sure it is free of limescale before i fitted a pump to it.

Hi I would check the neck of the tank and pipework off of it for limescale. HTH

Hi Firstly you need to identify the pipe used. There is more than one manufacturer and while most will fit together non will accept responsibilty if you mix them. Then a trip to the plumbers merchant for pipe and fittings not forgetting the inserts. HTH

Hi Could you leave the cistern off, fit the pan and check water tight with buckets of water?

Hi If possible, check that there are no more than three rads on the leg as pump pressure would be almost lost when all the rads are on. HTH

Hi Sounds like option 2 is the least expensive and the least time consuming. I like to see a hose clip fitted just to be sure it stays put.

A picture would help identify the flush valve. On certain types of flush valves the rubber seal blisters and then fails to seat properly with the base.

Hi Hot water up in the plastic tank is not good. I sugest a professional look at it as soon as possible. Hot water going out overflow won't hurt coming through ceiling is another matter.

Hi The joints could be asbestos and should be disposed of correctly.

Hi Do you know the manufacturer. It sounds like a flush valve seating problem.

Is the cold in 15mm? A 15mm-3/4 flexi can be bought from must plumbing merchants.

Hi Water authority is responsible.

Hi Make a washer out of a cardboard shoe box.

Is it possible to put in a vanity basin and cupboard? Or perhaps make a cupboard to fit the basin?

Hi Put the pedestal in the boxing.

Hi I think the red ring/collar should be inside the white nut.

Hi The most likely cause is the washer at the base of the flush valves is not sealing on the cistern nut outlet. The washer if grey in colour is prone to delaminating evident by blisters forming which when punctured bleed. The replacement washer are clear. HTH

Hi The wire you refer to is a low voltage interface cable between the proccessor board and the shower buttons. It sounds as if you've bought a faulty one of ebay.