Search results

Thank you all.

Thank You

Is there any coving and adhesive i could buy for bathroom ceiling to tile?. i.e Plasterboard to tile. we want to cover the tiling edge near the ceiling. Thank you.

Thanks Masona.

Hallway is big and wide for 2 rad's and it should circulate air more openly I think so I will go for 2 rad's. I'm just thinking, how about putting 1 upstairs in the hallway? Shall I do this? because generally speaking heat will rise up anyway. Thanks

Hi all, Any suggestion will be appreciated. We will be installing some new rad's, the hallway requires btu out put of 14000 I can either put 1 rad 600+1800 with double convector btu 14000 Or I can have 2 rad 600+1800 600+1400 with single convector, I have room for 2. My question...

Hi All, Need your opinion on this please. We are in the process of putting new radiators in the house which means there will be a lot of floor boards lifts and shifts so probably this is our chance to insulate the floor and replace it etc.... We are thinking of laying laminate floor...

Hi Masona, When you say shutting all radiators and than try, you mean switching the heating on? and see what happens. Correct? I'm just thinking If I experience a similar problem like this I can make a note from this for future reference. I'm getting some new radiators install very...

Hi Chris, Do you mean turn off all the RAD's vale which have problems :( ? And, then swith on the boiler? - This will force flow through the cold rad(s), hopefully pushing the air lock out of the pipe.

We were thing off laying Laminate floor in one 1 room. We have taken all the skirting board off because its in ban condition, it will be replaced with new ones. I was thinking, I know when you lay Laminate floor you leave an inch or less from the side of the wall and then you fill this gap...

Thank you for your reply,

Understandable, but radiators should be OK though?

I still don't understand this, i can't find any thing as described above. Could this be under the floor board? Thanks

Thanks Oilman, My mate as installed Boiler's and has repaired them. So I'm quite confidant that there should be no problem installing just 2 extra RAD. He say to me its very simple to do my project?

MANDATE "removes any air lock in pipe work and flushes out sludge from pipe work. This leaves only the bleeding of the radiators." Where do I find this air lock pipe? and how to I proceed. Regards

We have recently dismantled our chimney breast from upstairs to the ground floor. We had to summit a building control form from our local council and the technical surveyor informed us that we have to put a steel beam across from one side of the wall to the other side along with same steel...

I have a friend who thinks he can do this for me. However, what would be the safety precaution we should take. This friend has done this work before but his not Cogi Registered Appreciate you thoughts.

Hi All, When you say drain the upstair ones do you mean draing all the upstaire radiators? to replace a new radiators When you do this will that drain all the water from the upstair system pipe pipe? Please advise.... In about 4 weeks time we will be preparing to replace some of...

In about 4 weeks time we will be preparing to replace some of our old radiators and install some new one’s into the exiting place. Additional 2 extra radiators will be fitted into a new location i.e. in the Kitchen and upstairs hallway. We have a comi boiler 24kw – sealed system...

Hi, BDL has made an very important point so therefore I need to ask everyone there opinion on this. Can someone tell me please for my safety reason, what can a DYIer can do and can't do in the following areas :? . Water Tanks, Boiler, Gas, Controls & Wiring, Radiator & Valves: Motorised...