Search results

As said before, it was the installers naivity for not pre warning you of the possible outcome. However its not a statuary obligation

Is an SCR the same as a DCR or an MP3 or a DVD or an IBM ?

Why women under specifically 44

Got to say that was most helpful :?, your not related to Victor Meldrew are you?

Just fit a 10mm non return valve outside and single pipe to pump...Sorted

If it cuts off after 20 seconds and then comes on after 10mins, then you've a circuitory problem on Flow/Return or a partial blocked coil on cylinder. That's why its kettling on temp over 60c

More than likely this will be ok, best to drain cylinder down, remove that blank and fit a 22mm Iso valve. Connect 22mm Copper pipe.Fill up then test with pipe into a bucket. If ok then that's suitable for your hot to pump. Don't forget to cap the other 15mm feed to shower off top of cylinder

Need a photo of your set up, where is the boiler in relationship to cylinder ? Is it an up and over flow and return ?, does the flow go over the top and the return underneath to the cylinder ? fotos, fotos fotos :wink:

Wastepipes should be seperate to each Sanitaryware, however you might get over noise on Bath by fitting a deep seal trap about 75mm.

Throw it in the skip and get yerself a Salamander, far better quality.

It sounds like a blocked cold feed on the return, if the boiler fires up on hot water and then reaches temperature quickly and shuts off, then that would indicate no circulation on the coil of the cylinder.......Seemples :wink:

You sure its unvented, are you a Plumber ?

Chuck the bloody thing out and fit an External Grant. Seemples

And then keep an eye on the ceiling below for the foreseable future :wink:

Lazy Gasman never wiped his pipe clean after soldering(flux residue) Maybe should've speedfit, no flux residue after :wink:

Youll more than likely end up with repipe I,m afraid. Only way round it

Also check ballvalves in tanks and cisterns, probably partially blocked aswell

Newark Cylinders Notts, do bespoke Combi vented cylinders to suit your needs, give em a bell

I have to add to this, what is the matter with some lazy arsed Engineers not being able to get to this sort of easy work for a whole week. 10 mins work to get a family heat and hot water. Beggers belief

What an ungrateful Rsole :twisted: