Search results

Copper sheet under glass?

Wheres the glue on veneer from?

Looks brilliant... thankyou

We've inherited a home with 18mm ply kitchen worktops but never surface finished. They are sound and fit well. What could I face them with to finish off? Tiles or other? Thankyou..

Wall got 2 electronic sockets and looking for something to cover them as maybe a shelf etc to tidy the appearance. As attached.

They already did that. The board is very poor quality and nibbled all over. What about block s?

Scenario.. About 20 coasters on top of one another sort of does what's needed. Coasters screwed in to unit from inside of base panel. Height adjustment .... less or more coasters or some sort of gasket for more height adjustment

Unit must have been moved a lot by previous folk so damage done. Anyway what about some 100x100x18 ply plate fixed to unit corners. Then maybe a bolt and other plate to allow adjust?

Couple of kitchen floor units are cheapish flat pack. Over time the little plastic adjustable legs seem to have come off and then re screwed to the unit. Loads of screw hole attempts needs a fix. Could I get some chunky wooden blocks with a bit of height adjustment that may be better than those...

Side of P Shape Bath/Shower needs some sort of perspex type screen that fits the roof line of Dormer wall side. Previously was just cheap waterproof panel attached to plasterboard. Was thinking along lines of attached image. The screen attached to bath is ok so will keep. Maybe you can buy such...

Was told showers that run off combi boilers for hot water also require a flow balance control unit which slows the flow of the cold water before it gets to the mixer thermostat. Otherwise the thermostat has to do a lot more work and will break. Also something about the shower needing to be...

We can live with the fact that the Combi Boiler drops pressure on other taps when one in use etc. BUT Were thinking of putting a Bathroom Shower in and not sure if the water power needs to be boosted. All this aside from above. SO Question is can a shower unit be sourced that ''sort of' boosts...

Great advice dilalio.. so grateful.. thx

Ref question... Need to raise bath around minimum 200mm As there was a Combi Boiler fitted recently, the upstairs bath doesnt take cold supply from removed loft tank but now comes from mains supply. Hot supply comes from combi; also upstairs. Not sure of the importance of this in your comment...

I've a 1972 built house. We bought it recently. Original Taps (to its Bäth attached) are as the image shown. Not sure of size of 1972 pipework. Pipes shown. Want to be able to raise height of bath so extend pipe for tap attachment. Theres no isolation an also i thought of using one as shown...

Thanks oldbuffer

I only put a new blue isolation valve as wanting to connect a new flexi tap pipe to it. Unless 2 isolation valves is bad practice?. I suppose something that has same double screw ends as an isolation valve, but no actual valve if such thing existed?. In fact its similar to thread connecting a...

Need some yellow coloured elbows which can be thread connected . Yellow shown in attached picture.. Sorry :-)

As 'A' in attached. Got an existing setup where isolation valve and connected water pipe are in a boxed and tiled area. Theres also existing concrete above (gap shown). Wanting a way (as 'B') to put some sort of thread connected double elbow (ideally without pipework between) and another...

Noticed in Post Office some wall panels. Looked smart. Looked like 150x15mm lengths of White Melamine Faced Chipboard and Aluminium channel in gaps. . Question is "what is it" or anyone constructed similar?. Any detail. Image attached.