you will be fine not leaving a gap with engineered
I have fitted the whole of peoples down stairs with engineered many a time without stopping at doorways and never had a single problem
get yourself a pretty decent fine tooth handsaw.. mark were your going to cut with a pencil then a knife then tape up the opposite side of the line and cutttttt
oil and hardwax oil may turn well turn your blocks orange. If it was me i would use bona mega or traffic lacquer to keep the colour lighter and when you fill the gaps with sawdwust and filler it wont show up as much.
a lot of oils reccomend sanding no higher than 120 grit always follow the...
I bought the recomended dewalt plunge saw blade dt1207 24 tooth but the problem is that its 1.5mm kerf and the riving knife is 1.7mm so when i go to cut it sticks has anyone got any soloutions to this???/
i take it the floor is oak. if it is it will go a light yellow once the hardwax oil goes on it. if you run a damp rag over a small area it will be a good indication if what the finish{colour} will look like. If you want the floor to look like how it is now with out any finish on it (the bare...
i personaly dont like varnish on parquet flooring...It depends on the wood if it is dark wood i would always go for a wax oil for looks.. A hard wax oil has a slitly better wear level than normal wax oil but doesn,t lift the look of the floor as much
You would probably better going with the...
you should never mix pva and saw dust. it ends up going turning black especially if your using oil on your floor, the oil would turn it jet black.
typical builder always ask a professional floor layer for advice never a builder